Maintenance and Troubleshooting

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 5 on page 8 for replacement instructions. If the handgrip pulse sen- sor does not function properly, see step 5 on page 16.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the reed switch should be adjusted. First, remove all of the screws from both shields; there are three sizes of

screws in the shields--note which size of screw

you remove from each hole. Then, gently pry the shields away from the frame.

Next, locate the

Reed Switch58

(58). Turn the

Left Pedal Disc

(26)until the Magnet (41) is

aligned with the Reed Switch.

Loosen, but do not remove, the indicated M4 x 16mm Screw

(84). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Rock the Left Pedal Disc forward and backward just enough that the Magnet passes the Reed Switch repeatedly.

Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the shields. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24.

HOW TO ADJUST THE BELT

If you can feel the pedals slip while

you are pedaling, even when the

resistance of the pedals is at the highest setting,

the Belt (46) may need to be

adjusted. First, remove all the

screws from both

shields; there are three sizes of screws in the shields--note which size of screw you remove

from each hole. Then, gently pry the shields away from the frame.

Next, turn the Belt Adjustment Screw (72) until the Belt

(46)is tight. Then, reattach the shields. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24.