JVC RX-1024VBK manual Basic Operations, On the front panel only, From the remote control only

Basic Operations

Selecting the Front Speakers

On the front panel only:

SPEAKERS

12

When you have connected two pairs of the front speakers, you can select which to use.

Press SPEAKERS 1 or SPEAKERS 2 to select the speaker to use.

Each time you press the button, the lamp on the respective button turns on and off. When the lamp on either button lights up, the respective speakers are activated.

IMPORTANT:

You can activate two pairs of the front speakers at the same time only when the SPEAKER LOAD SELECTOR on the rear panel is set to “HIGH” and when no signals are sent to the center and rear speakers. Otherwise, activating one pair of the speakers deactivates the other.

Listening only with headphones

1.Connect a pair of headphones to the PHONES jack on the front panel.

2.Press SPEAKERS 1 and/or 2 so that no lamps on the buttons are turned on.

Muting the Sound

From the remote control only:

Press MUTE to mute the sound through all speakers and MUTE

headphones connected.

“MUTE” appears on the display and the volume turns off (the volume level indicator also goes off).

To restore the sound, press MUTE again so that “OFF” appears on the display. Turning MASTER VOLUME or pressing VOLUME +/– also restores the sound at the previous volume level.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night.

From the remote control only:

Press SLEEP repeatedly. SLEEP

The SLEEP indicator lights up on the display, and the shut-off time on the display changes as follows.

=SLEEP 10min. = SLEEP 20min. =SLEEP 30min. =SLEEP 40min.

=SLEEP 50min. = SLEEP 60min. =SLEEP 70min. =SLEEP 80min.

=SLEEP 90min. = SLEEP 00min. (Canceled) = (back to the beginning)

When the shut-off time comes

The receiver turns off automatically.

To check or change the time remaining until the shut-off time

Press SLEEP once. The remaining time until the shut-off time appears in minutes.

•To change the shut-off time, press SLEEP repeatedly.

To cancel the Sleep Timer

Press SLEEP repeatedly until “SLEEP 00min.” appears on the display. (The SLEEP indicator goes off.)

Turning off the power also cancels the Sleep Timer.

Note:

If you use any of the DSP modes other than the 3D- PHONIC modes and “HEADPHONE” with both front speakers activated, the speakers connected to the

FRONT SPEAKERS 2 terminals are deactivated.

CAUTION:

Be sure to turn down the volume before connecting or putting on headphones, as high volume can damage both the headphones and your hearing.

Note:

You cannot shut off the sound through the subwoofer using the SPEAKERS 1 and 2 buttons.

Note:

When the TV is connected to the TV SOUND/DBS jacks on the rear:

The receiver will turn on soon again after the Sleep Timer shut off the receiver if the TV is kept turned on.

To prevent this from happening, make sure that you turn off the TV before the Sleep Timer turns off the receiver.

15