JVC RX-1024VBK manual On the front panel, DSP and Theater indicators also light up on the display

Using the DSP Modes

On the front panel:

You can also use the buttons on the front panel to adjust the Theater Surround mode. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

1. Select and play the source encoded with Dolby Digital (bearing the mark

) or with Dolby Surround (bearing the mark		).
	DOLBY SURROUND

D I G I T A L

•When you play back the source encoded with Dolby Digital and select the digital input for that source, the Ù DIGITAL indicator lights up on the display.

Notes:

•	To enjoy the software encoded
	with Dolby Digital, you must
	connect the source
	component using the digital
	terminal on the rear of this
	receiver.
•	The Surround mode is not
	used with the other DSP
	modes such as the DAP mode

2.Press DSP MODE.

The current DSP mode appears on the display.

3.Turn MULTI JOG until “THEATER” or “DIG- THEATER” appears on the display, while the indication of the previous step is still on the display.

The DSP and THEATER indicators also light up on the display.

DSP MODE

MULTI JOG

and 3D-PHONIC mode. When

the Surround mode is turned

on, the other DSP mode, if

used, will be turned off.

Notes on the indications:

As you turn it, the DSP modes change as follows:

When the digital input is selected to play the source encoded with Dolby Digital:

DIG-THEATER	HEADPHONE
DSP OFF		3D DIGITAL

For other sources:

		THEATER		LIVE CLUB		DANCE CLUB		HALL
DSP OFF								PAVILION
	3D THEATER		3D DRAMA		3D ACTION		HEADPHONE

If you need to make any adjustment, go to the following steps.

•The PRO LOGIC indicator lights up when the Dolby Pro Logic decoder built in this receiver is activated.

•The Dolby Pro Logic decoder is used not only for the analog sources but also for the sources encoded with Dolby Digital in the following cases:

–When only front channel signals are encoded.

–When front channel and

monaural rear channel signals are encoded.

While the Dolby Pro Logic is activated for this type of Dolby Digital source, the Ù DIGITAL indicator goes off.

4.Adjust the speaker output levels as follows.

1)Press BALANCE/SURROUND ADJUST repeatedly until one of the indications appears on the display. “CENTER LEVEL”: To adjust the center speaker level. “REAR L LEVEL”: To adjust the left speaker level. “REAR R LEVEL”: To adjust the right speaker level.

2)Turn MULTI JOG to adjust the selected speaker output level (from –10 dB to +10 dB), while the indication of the previous step is still on the display.

3)Repeat 1) and 2) to adjust the other speaker output levels.

BALANCE/SURROUND

ADJUST

MULTI JOG

Notes:

•You cannot adjust the center speaker level when “CENTER SPK” is set to “NONE” (see page 19).

•You cannot adjust the rear speaker levels when “REAR SPK” is set to “NONE” (see page 19).

39