JVC RX-1024VBK manual Connecting the front speakers, Connecting the Speakers

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly to obtain the best possible performance. For details, see pages 18 and 19.

For each speaker (except for subwoofer), connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers. For connecting a subwoofer, see page 7.

1	2			3	4
		1		1	1
			RIGHT	RIGHT	RIGHT

CAUTION:

Use speakers with the

SPEAKER IMPEDANCE indicated by the speaker terminals.

1Cut, twist and remove the insulation at the end of each speaker signal cable.

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Connecting the front speakers

Connect the front speakers to the FRONT SPEAKERS terminals.

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another pair to the FRONT SPEAKERS 2 terminals).

1					SPEAKER	SPEAKER LOAD
+	–	–	+	1	LOAD	POSITIONED LOW
					SELECTOR	SPEAKER LESS
					LOW	4 ~ 6
					HIGH	8 ~ 16
2						SPEAKER
						IMPEDANCE
RIGHT		LEFT		2		/ OHMS
	FRONT SPEAKERS

Left speaker Right speaker

Note:

To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:

•Set it to the HIGH position when the impedance of the speakers connected is within the range of 8 ohms to 16 ohms.

•Set it to the LOW position when the impedance of the speakers connected is within the range of 4 ohms to 6 ohms.

•Set it to the LOW position when the impedance of the any speaker connected is 6 ohms or less.

6