JVC RX-1024VBK manual Receiving Radio Broadcasts, Assigning Names to Preset Stations

Receiving Radio Broadcasts

Assigning Names to Preset Stations

You can assign a name of up to four characters to each preset station. When a preset station is tuned in, its assigned name will appear on the display.

On the front panel only:

1.Tune in a preset station. See page 24 for details.

2.Press TUNER/SEA MEMORY.

The preset channel number starts flashing for about 5 seconds.

CH–

TUNER/SEA MEMORY

Note:

If you turn MULTI JOG while the preset channel number is flashing, you can change

the preset channel number.

3.Press TUNER PRESET, while the preset channel number is flashing.

The first character position starts flashing.

CH–

VOLUME

4.Turn MULTI JOG to select the first character, while the first character position is flashing..

You can use characters listed below.

CH–

VOLUME

TUNER PRESET

MULTI JOG

Note on step 3 to 7:

You cannot select any entry after the indication on the display stops flashing.

In this case, repeat the procedure from step 2 again.

5. Press TUNER PRESET, while a character you want is	TUNER PRESET
flashing.

The next (or previous) character position starts flashing.

		CH–
		VOLUME
6.	Repeat steps 4 and 5 to enter up to four characters.
7.	Press TUNER/SEA MEMORY while the last selected		TUNER/SEA MEMORY

character is flashing after you have assigned a name.

To erase the input characters

Insert spaces using the same procedure described above.

MULTI JOG

Available characters

Space
	A B C D E F G H I J K L M N O
P Q R S T					U V W X Y Z 0 1 2 3 4
5	6	7	8	9

25