JVC RX-1024VBK manual Low Frequency Effect Attenuator Setting, Dynamic Range Compression Setting

Basic Settings

2.Turn MULTI JOG to select the crossover frequency level according to the size of the small speaker connected, while the indication of the previous step is still on the display. As you turn it, the display changes to show the following:

CROSS: 80HzCROSS:100Hz CROSS:120Hz

CROSS: 80Hz	Select this when the cone speaker unit built in the speaker is
	about 4 3/4 inches (12 cm).
CROSS:100Hz	Select this when the cone speaker unit built in the speaker is
	about 3 15/16 inches (10 cm).
CROSS:120Hz	Select this when the cone speaker unit built in the speaker is
	about 3 3/16 inches (8 cm).

Low Frequency Effect Attenuator Setting

If the bass sound is distorted while playing back a source using Dolby Digital, follow the procedure below.

On the front panel only:

1. Press SETTING repeatedly until “LFE ATT” (Low	SETTING
Frequency Effect Attenuator) appears on the display.

The display changes to show the current setting.

2. Turn MULTI JOG to select the low frequency effect	MULTI JOG
attenuator level, while the indication of the previous step is
still on the display.

As you turn it, the display changes to show the following:

LFE ATT: 0dB LFE ATT:10dB

LFE ATT: 0dB:	Normally select this.
LFE ATT:10dB:	Select this when the bass sound is distorted.

Dynamic Range Compression Setting

You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night.

On the front panel only:

SETTING

1.Press SETTING repeatedly until “D. RANGE COMP.” (Dynamic Range Compression) appears on the display. The display changes to show the current setting.

2. Turn MULTI JOG to select the appropriate item about the	MULTI JOG
compression level, while the indication of the previous step
is still on the display.

As you turn it, the display changes to show the following:

COMP.: OFF COMP.: MID COMP.: MAX

COMP.: OFF	Select this when you want to enjoy surround with its full
	dynamic range. (No effect applied.)
COMP.: MID	Select this when you want to reduce the dynamic range a
	little. (Factory setting).
COMP.: MAX	Select this when you want to apply the compression effect
	fully. (Useful at night).

Note:

This function takes effect only when playing back a sources using the Dolby Digital.

Note:

This function takes effect only when playing back a sources using the Dolby Digital.

21