JVC RX-1024VBK manual Using the DSP Modes, Using the 3D-PHONIC Modes

Using the DSP Modes

	IMPORTANT:
	When using the Remote Control, check to see if its remote control
TV/VCR	mode selector is set to the correct position:
AUDIO/
CATV	To operate this receiver, set it to “AUDIO/TV/VCR” (except when
DBS
	selecting the DBS tuner as the source).

Using the 3D-PHONIC Modes

When using the 3D-PHONIC modes, you need only two front speakers to reproduce the

soundtracks of software encoded with Dolby Digital (bearing the mark			) or
with Dolby Surround (bearing the mark		).	D I G I T A L
	DOLBY SURROUND

On the front panel:

1. Select and play the source encoded with Dolby Digital (bearing the mark ) or with Dolby Surround (bearing the mark DOLBY SURROUND ).

D I G I T A L

•When you play back the source encoded with Dolby Digital and select the digital input for that source, the ÙDIGITAL indicator lights up on the display.

DSP MODE

2.Press DSP MODE.

The current DSP mode appears on the display.

3.Turn MULTI JOG until the mode — 3D ACTION (or 3D

MULTI JOG

DIGITAL), 3D DRAMA, or 3D THEATER — you want appears on the display, while the indication of the previous step is still on the display.

As you turn it, the DSP modes change as follows (the 3D-

PHONIC and DSP indicators also light up on the display):

When the digital input is selected to play the source encoded with Dolby Digital:

DIG-THEATERHEADPHONE

DSP OFF 3D DIGITAL

For other sources:

THEATER LIVE CLUB DANCE CLUB HALL

DSP OFF				PAVILION
	3D THEATER	3D DRAMA	3D ACTION	HEADPHONE

3D ACTION:	Best for action and war movies — where the action is fast and
	explosive.
3D DRAMA:	Best for dramas and romantic movies — where the action is
	slow and soft.
3D THEATER:	Reproduces the sound field of a theater.
3D DIGITAL:	Reproduces multi-sound source encoded with Dolby Digital.
DSP OFF:	No DSP mode is applied.

For the other modes, see pages 32 and 37.

If you need to make any adjustment, go to the following steps.

Notes:

•To enjoy the software encoded with Dolby Digital, you must connect the source component using the digital terminal on the rear of this receiver.

•The 3D-PHONIC mode is not used with the other DSP modes such as the DAP mode and the Surround mode. When the 3D-PHONIC mode is turned on, the other DSP mode, if used, will be turned off.

Notes on the indications:

•The indicator of the selected DSP mode also lights up on the display while selecting.

•The PRO LOGIC indicator lights up when the Dolby Pro Logic decoder built in this receiver is activated.

•The Dolby Pro Logic decoder is used not only for the analog sources but also for the sources encoded with Dolby Digital in the following cases:

–When only front channel signals are encoded.

–When front channel and

monaural rear channel signals are encoded.

While the Dolby Pro Logic is activated for this type of Dolby Digital source, the Ù DIGITAL indicator goes off.

29