JVC RX-1024VBK Basic Settings, Selecting the DBS tuner as the source, Changing the Source Name

Basic Settings

Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier.

	IMPORTANT:
	When using the Remote Control, check to see if its remote control
TV/VCR	mode selector is set to the correct position:
AUDIO/
CATV	To operate this receiver, set it to “AUDIO/TV/VCR” (except when
DBS
	selecting the DBS tuner as the source).

Changing the Source Name

If you have connected an MD recorder to the TAPE/MD jacks or the DBS tuner to the TV SOUND/DBS jacks on the rear panel, change the source name shown on the display when you select the MD recorder or DBS tuner as the source.

Note:

Without changing the source name, you can still use the connected components.

On the front panel only:

1.When changing the source name from “TAPE” to “MD”:

•Turn SOURCE SELECTOR until “TAPE” appears. When changing the source name from “TV SOUND” to “DBS”:

•Turn SOURCE SELECTOR until “TV SOUND” appears.

2.Press and hold SOURCE NAME until “ASSGN. MD” or “ASSGN. DBS” appears on the display.

SOURCE SELECTOR

LOUDNESS

SOURCENAME

However, there may be some inconvenience.

– “TAPE” or “TV SOUND” will

appear on the display when

you select the MD recorder or

DBS tuner.

– You cannot use the digital

input (see below) for the MD

recorder and the DBS tuner.

– You cannot use the COMPU

LINK remote control system

(see page 48) to operate the

MD recorder.

To change the source names to “TAPE” or “TV SOUND,” repeat the same procedure above (in step 1, select “MD” or “DBS” then press and hold SOURCE NAME).

Selecting the Input Mode

When you have connected some components such as CD player, MD recorder, DVD player and the DBS tuner using digital terminals (see page 11), you need to change the input mode for these components to the digital input.

Note:

Once you have set the digital input for these components, it is always used every time you

On the front panel:

1.Turn SOURCE SELECTOR until the source (CD, MD, DBS, or DVD) for which you want to change the input mode from analog input to digital input.

2.Press DIGITAL INPUT to change the input mode. Each time you press the button, the input mode alternates between the digital input and analog input.

SOURCE SELECTOR

DIGITAL INPUT

select these components as the source.

From the remote control:

1.Press the source selecting button (CD, TAPE/MD, TV/DBS, or DVD) for which you want to change the input mode from analog input to digital input.

2.Press DIGITAL/ANALOG INPUT to change the input mode.

Each time you press the button, the input mode alternates between the digital input and analog input.

DVD	VCR 1	VCR 2	VIDEO
CD	TAPE/MD	PHONO	TV/DBS
AM	FM

DIGITAL/

ANALOG

INPUT

17