JVC RX-1024VBK Attenuating the Input Signal, Adjusting the Subwoofer Output Level, Press Sound

Attenuating the Input Signal

When the input level of the playing source through the analog terminals is too high, the sounds will be distorted. If this happens, you need to attenuate the input signal level to prevent the sound distortion.

Notes:

• This function is available only

for the sources connected

using the analog terminals.

On the front panel only:

Press and hold SOUND SELECT/INPUT ATT until “INPUT ATT ON” appears on the display.

The ATT indicator also lights up on the display.

Each time you press and hold the button, the input attenuator mode turns on (“INPUT ATT ON”) and off (“INPUT NORMAL”).

You can set input attenuator mode separately for each source.

SOUND SELECT

INPUT ATT.

• This function takes effect only

when the DSP mode is in use.

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected “YES” for the “SUBWOOFER” (see page 18).

Once it has been adjusted, the receiver memorizes the adjustment.

On the front panel:

1.Press BALANCE/SURROUND ADJUST repeatedly until “SUBWFR LEVEL” appears on the display.

The display changes to show the current setting.

2.Turn MULTI JOG to adjust the subwoofer output level (– 10 dB to +10 dB), while the indication of the previous step is still on the display.

From the remote control:

1.Press SOUND.

10 keys are activated for sound adjustments.

BALANCE/SURROUND

ADJUST

MULTI JOG

SOUND

–SUBWOOFER +

2.Press SUBWOOFER +/– to adjust the subwoofer output level (–10 dB to +10 dB).

Recording a Source

0+10

FM MODE/ 100+

MUTE

You can record any source playing through the receiver to the cassette deck or the MD recorder connected to the TAPE/MD jacks and the VCRs connected to the VCR1 and VCR2 jacks at the same time.

While recording, you can listen to the selected sound source at whatever sound level you like, without affecting the sound levels of the recording.

Note:

The output volume level and SEA modes cannot affect the recording.

IMPORTANT:

When recording the digital source, turn off the DSP mode.

16