Operation:
Note:
•The minimum distance between the transmitter (operator) and the receiver (machine) is 2 metres. If the the minimum distance is not adhered to, the safety
•If the minimum distance is not adhered to during operation, the engine continues to run but the machine comes to a standstill. In both cases, increase the distance and repeat the process.
•If several machines are in use at the same location, the addresses must be coordinated.
iDanger
Switching errors or malfunctions can be caused as a result of identical frequencies!!!
5.4Switching on and reversing the direction of travel
•Travel levers „FL“ and „FR“ in „front“ position: Machine travels forwards.
•Travel levers „FL“ and „FR“ in „back“ position: Machine travels backwards.
•If the travel levers are moved in opposite directions, the machine travels around its vertical axis (on the spot).
•The machine comes to a stop when the travel levers are not actuated.
5.5Driving at high speed
20
•Driving at high speed is only possible if the switching lever „E“ is pushed forwards. (Fig. 20)
•Operate both travel levers „FL“ and „FR“ as for normal operation.
Note:
The roller travels at twice the speed in the „high speed“ mode.
E
5.6Driving with vibration
•Vibration is switched on when the switching lever „V“ is pressed forwards or back (Fig. 21).
•If the switching lever is pushed forwards, the vibration runs „forwards“, if the lever is pushed back, it runs „in reverse“.
•In even terrain, the switch position is of no consequence.
•However, if the machine has to negotiate an incline, the vibration be switched to the direction of travel in order to increase the machine‘s climbing ability.
21
25