Multiquip P33/24 HHMR Changing the engine oil, Hydraulic oil change, 12.1Hydraulic system

Page 34

Maintenance:

9.11 Changing the engine oil

Remark:

Drain the engine oil only when the engine is warm. Change intervals for engine oil, see the Hatz 2G40 Manual (Annex).

iDanger

Danger of scalding!

Risk of scalding when draining hot engine oil!

35		36

S

M E

• Disconnect oil drainage hose „S“ and remove plug „M“ (Fig. 35).

• Collect the oil in a suitable container and37 dispose of in an environmentally responsible manner.

•Oil ﬁ lter change (Fig. 37)

•Connect the oil drain hose and top up with new oil at the ﬁ lling hole „E“ (Fig. 36).

ÖF

9.12 Hydraulic oil change

iDanger

Danger of scalding!

Risk of scalding when draining hot hydraulic oil!

9.12.1Hydraulic system

Maintenance work on the hydraulic system is essentially limited to the ﬁ lter and hydraulic oil tank. All other units require no maintenance. The hydraulic line network should, however, be checked at regular intervals for leaks. Do not spray hydraulic lines with paint.

34

Image 34

Contents Vibratory Trench Roller P33/24 Hhmr Page Foreword 12345 Table of Contents Operation with remote control Jump start device Loading and transport Maintenance850 mm 1200 mm 630 mm 1520 mm 500 mm 855 mm 1780 mm Main dimensions RW 1504 /HF/HK/FK/HFKSteering Noise and vibration speciﬁcations Rammax RWFields of application DescriptionModiﬁcations to the machine Safety regulations Intended use Operation of the machineLoading the machine for transport Safety signs attached to the machineStarting the machine Driving the machine Parking on uphill and downhill slopes Maintenance workRefuelling Work on hydraulic linesRepairs Display and operating elements Cockpit TransmitterDescription of the display and operating elements ÖK Oil pressure warning lightSZ Hourmeter Engine safety support Back-up safety barAddress setting Operation Operation with remote controlPrecommissioning checks Zone BStarting the engine Driving at high speed Switching on and reversing the direction of travelDriving with vibration Starting process Switching off the machineManual control Travel operationVibration Jump start device FSE Loading and transportGeneral remarks on maintenance and maintenance work MaintenanceRunning in regulations Maintenance schedule Every day Checking the hydraulic oil level Check engine oil level Checking the fuel level Battery Changing the fuel ﬁlterChecking / cleaning / replacing the air ﬁlter Changing the transmission oilHydraulic oil change Changing the engine oil12.1Hydraulic system High-pressure line ﬁlter Adjusting the stripper Changing the suction ﬁlterTightening torques for bolts with standard metric thread Bolt size Tightening torques NmTroubleshooting table Heres HOW to GET Help