Multiquip P33/24 HHMR operation manual Check engine oil level, Checking the hydraulic oil level

Page 31

Maintenance:

9.04 Check engine oil level

Remark:

Park the machine on an even, load-bearing surface in such a way that it is horizontal.

•Pull out the oil dip stick „MS“ and wipe off with a lint-free cloth (Fig. 29).

•Insert the oil dip stick as far as it will go and pull out again.

•The oil level must be between the two marks.

•If the oil level is below the bottom mark, top up with oil immediately.

For suitable oil types, see the Hatz 2G40 manual!

29

E

9.05 Checking the hydraulic oil level

Remark:

Park the machine on an even, load-bearing surface in such a way that it is horizontal.

•Check the hydraulic oil level at the oil sight glass under the engine hood.

•Only check the oil level when the engine is cold. The hydraulic oil should come up to the middle of the sight glass.

•If necessary, top up with hydraulic oil.

Recommended oil types: Mobil HPL 46, Texaco Rando HD-C. Equivalent oil types from other manufacturers can be used.

Remark:

If it is discovered during the daily oil level check that there is hydraulic oil missing, Check all units, pipelines and houses immediately for leaks.

9.06 Checking the fuel level

iDanger Danger of fire!

When working with the fuel system, no naked fl ames,

no smoking. Do not refuel in enclosed areas. Do not breathe in fuel fumes.

Note:

Contaminated fuel can lead to the failure of or damage to the engine.

30

If necessary, top up fuel through a sieve fi lter.

Clean the area surrounding the fi lling hole and refuel. Fuel: See the Hatz 2G40 operating manual!

(Annex)

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Vibratory Trench Roller P33/24 Hhmr Page Foreword 12345 Table of Contents Jump start device Loading and transport Maintenance Operation with remote control850 mm 1200 mm 630 mm 1520 mm 500 mm 855 mm 1780 mm RW 1504 /HF/HK/FK/HFK Main dimensionsSteering Rammax RW Noise and vibration specificationsFields of application DescriptionModifications to the machine Safety regulations Operation of the machine Intended useLoading the machine for transport Safety signs attached to the machineStarting the machine Driving the machine Work on hydraulic lines Maintenance workRefuelling Parking on uphill and downhill slopesRepairs Cockpit Transmitter Display and operating elementsÖK Oil pressure warning light Description of the display and operating elementsSZ Hourmeter Engine safety support Back-up safety barAddress setting Zone B Operation with remote controlPrecommissioning checks OperationStarting the engine Driving at high speed Switching on and reversing the direction of travelDriving with vibration Travel operation Switching off the machineManual control Starting processVibration Loading and transport Jump start device FSEGeneral remarks on maintenance and maintenance work MaintenanceRunning in regulations Every day Maintenance scheduleChecking the hydraulic oil level Check engine oil levelChecking the fuel level Changing the fuel filter BatteryChanging the transmission oil Checking / cleaning / replacing the air filterHydraulic oil change Changing the engine oil12.1Hydraulic system High-pressure line filter Changing the suction filter Adjusting the stripperBolt size Tightening torques Nm Tightening torques for bolts with standard metric threadTroubleshooting table Heres HOW to GET Help
Top Page Image Contents