Multiquip P33/24 HHMR operation manual Back-up safety bar, Engine safety support, Address setting

Page 22

Operation:

4.2Back-up safety bar

Forward travel:	No function!
Reverse travel:	If the back-up safety bar is actuated,
	the machine automatically comes to an
	immediate stop.
Moving clear:	Move Both travel levers „FR“ and
	„FL“ to the „front“ position, the
	machine travels away from the
	obstacle!

4.3Engine safety support

Used for ﬁ lling the fuel tank or when the engine hood is opened to carry out repairs. The hood is safeguarded against dropping by the gas pressure spring.

iDanger

The engine hood falling down can lead to serious injury!

The gas compression spring must not be removed and must always replaced in order to exclude the danger of injury..

4.4Address setting

•Open cover D.

•Loosen plug „S-A“ on the transmitter and receiver. (Fig. 13-15)

•Using a screwdriver, it is then possible to set up to four addresses.

Note:

•The addresses at the transmitter and receiver must correspond.

•Example: 0 - 0/9 - 9 etc.

10

11

1213

14			15

22

Image 22

Contents Vibratory Trench Roller P33/24 Hhmr Page Foreword 12345 Table of Contents Operation with remote control Jump start device Loading and transport Maintenance850 mm 1200 mm 630 mm 1520 mm 500 mm 855 mm 1780 mm Main dimensions RW 1504 /HF/HK/FK/HFKSteering Noise and vibration speciﬁcations Rammax RWFields of application DescriptionModiﬁcations to the machine Safety regulations Intended use Operation of the machineLoading the machine for transport Safety signs attached to the machineStarting the machine Driving the machine Parking on uphill and downhill slopes Maintenance workRefuelling Work on hydraulic linesRepairs Display and operating elements Cockpit TransmitterDescription of the display and operating elements ÖK Oil pressure warning lightSZ Hourmeter Engine safety support Back-up safety barAddress setting Operation Operation with remote controlPrecommissioning checks Zone BStarting the engine Driving at high speed Switching on and reversing the direction of travelDriving with vibration Starting process Switching off the machineManual control Travel operationVibration Jump start device FSE Loading and transportGeneral remarks on maintenance and maintenance work MaintenanceRunning in regulations Maintenance schedule Every dayChecking the hydraulic oil level Check engine oil levelChecking the fuel level Battery Changing the fuel ﬁlterChecking / cleaning / replacing the air ﬁlter Changing the transmission oilHydraulic oil change Changing the engine oil12.1Hydraulic system High-pressure line ﬁlter Adjusting the stripper Changing the suction ﬁlterTightening torques for bolts with standard metric thread Bolt size Tightening torques NmTroubleshooting table Heres HOW to GET Help