Multiquip P33/24 HHMR operation manual Jump start device FSE, Loading and transport

Page 28

Operation:

7.0 Jump start device (FSE)

Note:

12 V system!!!

1.	Connect the jump start battery to the „+“ terminal and	27
	the „+“ terminal of the FSE to the machine.	27


2.	Connect the jump start battery to the „-“ terminal and
	the „-“ terminal of the FSE to the machine.
3.	Start the machine (page 26, section 6.1) Start
	procedure
4.	Disconnect the battery again in the reverse order.

Remark:

In order to avoid danger when connecting and disconnecting the battery,

connect the „+“ terminal ﬁ rst and disconnect it last. The „-“ terminal should never be connected alone.

8.0 Loading and transport

•To load the roller using hoisting gear, there is a central transport eye bolt „B“ in the middle of the roller (Fig. 28).

•The roller can also be loaded independently by being driven up a suitable loading ramp.

28

O O

Note:

•Only loading ramps with sufﬁ cient loading capacity and static stability must be used which exclude any possibility of personal injury.

•To lash the roller, always use shackles which are fastened to the transportation eye bolts „O“ (at the front and back of the central web).

•The roller must be lashed in such a way that it is secured against tipping over, slipping or rolling away.

•Do not walk or stand under suspended loads.

28

Image 28

Contents Vibratory Trench Roller P33/24 Hhmr Page Foreword 12345 Table of Contents Operation with remote control Jump start device Loading and transport Maintenance850 mm 1200 mm 630 mm 1520 mm 500 mm 855 mm 1780 mm Main dimensions RW 1504 /HF/HK/FK/HFKSteering Noise and vibration speciﬁcations Rammax RWFields of application DescriptionModiﬁcations to the machine Safety regulations Intended use Operation of the machineLoading the machine for transport Safety signs attached to the machineStarting the machine Driving the machine Maintenance work RefuellingParking on uphill and downhill slopes Work on hydraulic linesRepairs Display and operating elements Cockpit TransmitterDescription of the display and operating elements ÖK Oil pressure warning lightSZ Hourmeter Engine safety support Back-up safety barAddress setting Operation with remote control Precommissioning checksOperation Zone BStarting the engine Driving at high speed Switching on and reversing the direction of travel Driving with vibration Switching off the machine Manual controlStarting process Travel operationVibration Jump start device FSE Loading and transportGeneral remarks on maintenance and maintenance work MaintenanceRunning in regulations Maintenance schedule Every dayChecking the hydraulic oil level Check engine oil levelChecking the fuel level Battery Changing the fuel ﬁlterChecking / cleaning / replacing the air ﬁlter Changing the transmission oilHydraulic oil change Changing the engine oil12.1Hydraulic system High-pressure line ﬁlter Adjusting the stripper Changing the suction ﬁlterTightening torques for bolts with standard metric thread Bolt size Tightening torques NmTroubleshooting table Heres HOW to GET Help