Multiquip P33/24 HHMR operation manual Changing the fuel filter, Battery

Page 32

Maintenance:

9.07 Changing the fuel filter

Note:

When working on the fuel system, no naked fl ames, no smoking.

The diesel line fi lter „DF“ must be drained of water at least once a year or every

 

 

200 hours (Fig. 31).

 

To drain off the fi lter, the handwheel must be opened, until surplus water runs

 

31

 

away and pure diesel fuel emerges.

 

 

After draining, close the hand wheel and check the fi lter for leaks. Changing the fuel fi lter

Release both fi llister-head screws at the fi lter holder and remove the fuel fi lter „DF“ (Fig. 31).

Detach the fuel hoses and insert new fuel fi lter „DF“. Replace any fuel hoses that are porous or leaking.

Mount the fuel fi lter „DF“ in reverse order and check for leaks.

The fuel system is self-priming.

Note:

Collect any emerging fuel and dispose of in an environmentally responsible manner together with the fuel fi lter!

9.08 Battery

iDanger

When working with the battery, no naked flame, no smoking! Do not allow acid to come into contact with clothes or skin!

Wear protective goggles! Do not lay any tools on the battery!

The battery is located under the hood (Fig. 32). It is very important to keep the battery clean and to carry out maintenance correctly in order to have a perfect function of this battery. If the machine is out of action for a longer period of time the battery must be disconnected in order to prevent a deep discharge. Especially the terminals and clamps must be cleaned regularly and afterwards be coated thickly with an acidproof grease.

Note:

Dispose of old batteries correctly.

32

32

Image 32
Contents Vibratory Trench Roller P33/24 Hhmr Page Foreword 12345 Table of Contents Operation with remote control Jump start device Loading and transport Maintenance850 mm 1200 mm 630 mm 1520 mm 500 mm 855 mm 1780 mm Main dimensions RW 1504 /HF/HK/FK/HFKSteering Noise and vibration specifications Rammax RWModifications to the machine DescriptionFields of application Safety regulations Intended use Operation of the machineStarting the machine Safety signs attached to the machineLoading the machine for transport Driving the machine Maintenance work RefuellingParking on uphill and downhill slopes Work on hydraulic linesRepairs Display and operating elements Cockpit TransmitterDescription of the display and operating elements ÖK Oil pressure warning lightSZ Hourmeter Address setting Back-up safety barEngine safety support Operation with remote control Precommissioning checksOperation Zone BStarting the engine Driving with vibration Switching on and reversing the direction of travelDriving at high speed Switching off the machine Manual controlStarting process Travel operationVibration Jump start device FSE Loading and transport Running in regulations Maintenance General remarks on maintenance and maintenance work Maintenance schedule Every dayChecking the fuel level Check engine oil levelChecking the hydraulic oil level Battery Changing the fuel filterChecking / cleaning / replacing the air filter Changing the transmission oil12.1Hydraulic system Changing the engine oilHydraulic oil change High-pressure line filter Adjusting the stripper Changing the suction filterTightening torques for bolts with standard metric thread Bolt size Tightening torques NmTroubleshooting table Heres HOW to GET Help