Weider 831.159290 user manual ARM Assembly

FRAME ASSEMBLY

ARM ASSEMBLY

13. Attach the Leg Press Plate (11) to the	13
Adjustment Tube (10) with a 5/16” x 2 1/2”
	10
Bolt (39), two 5/16” Washers (20) and a 5/16”			40
		20
Nylon Locknut (40). Be sure that the Leg	48
Press Plate and Adjustment Tube are ori-
ented as shown.
Press a 1 3/4” Square Inner Cap (48) into the	39
Adjustment Tube (10).
	Angle		11
14. Attach the Adjustment Tube (10) to the Leg	14
Press Arm (9) with the Small Lock Pin (73).
	73		10
Be sure the Leg Press Plate (11) is orient-
ed as shown.
Press two 2” Square Inner Caps (56) into the
Leg Press Arm (9).			11
	9
			56
15. Locate and open the parts bag labeled	15
“ARM ASSEMBLY.”
Attach the Large Bumper (53) to the Front
Seat Frame (8) with the #10 x 1” Tap Screw
(100).	8
Lubricate the 3/8” x 3 1/4” Bolt (71). Attach		9
the Leg Press Arm (9) to the Press Base (13)			42
with the Bolt and a 3/8” Nylon Locknut (42).
	13		71—Lubricate
	53	100
16. Press a 1” x 7/8” Plastic Bushing (54) onto	16
each welded spacer on the Press Frame (12).
Slide the Press Frame onto the Press Base
(13) so that the Plastic Bushings are aligned
with the indicated tube. Note: This will be a
tight fit. Make sure that the higher hole is			Tube
on the side shown.
	Higher		12
Lubricate the 3/8” x 8” Bolt (52). Attach the
	Hole
Press Frame (12) to the Press Base (13) with	Welded		13
the Bolt and a 3/8” Nylon Locknut (42).
	Spacers
			52—Lubricate
	42		54

10