Weider 831.159290 user manual Weight Tubes are in the pin grooves in the upper Weights

Page 8

FRAME ASSEMBLY

8.Press a Weight Tube Bumper (26) into each Weight Tube (25).

Insert a Weight Tube (25) into each stack of Weights (90). Be sure that the pins on the

Weight Tubes are in the pin grooves in the upper Weights.

9.Lubricate the insides of the holes in the Top Weights (24) as shown. Slide a Top Weight onto each set of Weight Guides (23).

8

8
	25
	26
90	90
90
9
24
	23
Lubricate	Lubricate
	Lubricate
	24
23

Image 8

Contents Patent Pending Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Full 90 DAY WarrantyImportant Precautions Dimensions Before YOU BeginAssembly Following Tools not Included are Required for AssemblyFrame ASSEMBLY-PLASTIC LocknutsNylon Locknuts Do not fully tighten the Nylon LocknutsLocknut 40. Do not overtighten the Nylon Grooves are on the indicated side of each Stack of WeightsFully tighten the Nylon Locknuts Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet ARM Assembly ARM Assembly ARM Assembly Positioned to hold the Cable in the groove Pulley Find the Butterfly Cable 85-this isTrap must be oriented as shown and be End with Two holes Should be Down Cable Assembly Post Wide Tabs Must be On this Side Cable Assembly Cable Assembly Cable must be routed from the direction shown Find the Press Cable 88. Attach the end Plates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceLocknut until step Cable Assembly Seat Assembly Seat AssemblySeat Assembly High Pulley HOW to USE the Home GYM System Changing the Weight SettingAttaching the AB Strap to the AB Pulley Station Adjusting the LEG LeverAdjusting the LEG Press Plate Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesButterfly Cable Left Arm Right Arm Cable DiagramsPress Cable High Cable Long U Bracket Leg Press-13 Page Page X 3 1/4 Bolt Part LIST-Model No Qty DescriptionExploded DRAWING-Model No R0499AQUESTIONS?