Weider 831.159290 user manual ARM Assembly

Page 12

ARM ASSEMBLY

20.Press a 1 3/4” Square Inner Cap (48) into the lower end of the Left Arm (6). Wet the lower end of the Left Arm with soapy water. Slide a 10” Pad (22) onto the Left Arm.

Repeat this step with the Right Arm (5).

21.Press a 1 3/4” Square Inner Cap (48) into the top of the Leg Lever Frame (30).

Slide the Leg Lever Frame (30) into the Rear Seat Frame (16). Align one of the holes in the Leg Lever Frame with the upper hole in the Rear Seat Frame. Insert the Large Lock Pin (96) into the Rear Seat Frame.

Tighten the 1/4” x 5/8” Screw (99) into the lower hole in the Rear Seat Frame (16).

22.Press a 1 3/4” Square Inner Cap (48) into each end of the Leg Lever (15). Attach the Small Bumper (95) to the Leg Lever with a 1” Tap Screw (72).

Lubricate a 3/8” x 2 1/2” Bolt (65). Attach the Leg Lever (15) to the Leg Lever Frame (30) with the Bolt and a 3/8” Nylon Jam Nut (43).

20
	6
5
	48
22
	22
21
48
30
16	96
16
99
22
43	30
48
	65
72
15
95
48

12

Image 12

Contents Patent Pending Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Full 90 DAY WarrantyImportant Precautions Dimensions Before YOU BeginAssembly Following Tools not Included are Required for AssemblyFrame ASSEMBLY-PLASTIC LocknutsNylon Locknuts Do not fully tighten the Nylon LocknutsGrooves are on the indicated side of each Stack of Weights Fully tighten the Nylon LocknutsLocknut 40. Do not overtighten the Nylon Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet ARM Assembly ARM Assembly ARM Assembly Find the Butterfly Cable 85-this is Trap must be oriented as shown and bePositioned to hold the Cable in the groove Pulley End with Two holes Should be Down Cable Assembly Post Wide Tabs Must be On this Side Cable Assembly Cable Assembly Cable must be routed from the direction shown Find the Press Cable 88. Attach the end Plates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceLocknut until step Cable Assembly Seat Assembly Seat AssemblySeat Assembly High Pulley HOW to USE the Home GYM System Changing the Weight SettingAdjusting the LEG Lever Adjusting the LEG Press PlateAttaching the AB Strap to the AB Pulley Station Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams Press Cable High Cable Long U Bracket Leg Press-13Butterfly Cable Left Arm Right Arm Page Page X 3 1/4 Bolt Part LIST-Model No Qty DescriptionExploded DRAWING-Model No R0499AQUESTIONS?