Weider 831.159290 user manual End with Two holes Should be Down

Page 14

CABLE ASSEMBLY

26.Locate one of the pre-assembled pairs of Pulley Plates (31) and 3 1/2” Pulleys (82).

Route the Butterfly Cable (85) under the indi- cated 3 1/2” Pulley (82). The end of the Pulley Plates (31) with two holes should be down- ward. Refer to the inset drawing. Be sure that the Cable is between the Cable Trap

(80)and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.

Tighten the 3/8” x 2” Bolt (50) and the 3/8” Nylon Locknut (not shown).

27.Wrap the Butterfly Cable (85) around a 3 1/2” Pulley (82) as shown. Attach the Pulley and a Cable Trap (80) to the other side of the bracket on the Leg Press Upright (4) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). The

Cable Trap must be oriented as shown and be positioned to hold the Cable in the groove of the Pulley.

28.Note: The Left Arm (6) is shown removed for easier part identification. Slide the other end of the Butterfly Cable (85) onto a 3/8” x 1” Bolt (77). Insert the Bolt through the bracket on the Left Arm (6). Thread a 3/8” Nylon Locknut (42) onto the Bolt, but do not fully tighten it. Leave just enough room for the Cable to pivot.

26

 

 

 

85

 

82

50

 

 

 

 

End with

 

 

two holes

 

31

should be

 

 

down

 

 

 

89

 

 

80

27

 

 

 

80

50

 

 

 

42

85

 

82

 

 

 

4

 

28

 

 

 

77

 

 

85

 

 

42

6

 

 

14

Image 14
Contents Patent Pending Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Full 90 DAY WarrantyImportant Precautions Dimensions Before YOU BeginFrame ASSEMBLY-PLASTIC AssemblyFollowing Tools not Included are Required for Assembly LocknutsNylon Locknuts Do not fully tighten the Nylon LocknutsLocknut 40. Do not overtighten the Nylon Grooves are on the indicated side of each Stack of WeightsFully tighten the Nylon Locknuts Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet ARM Assembly ARM Assembly ARM Assembly Positioned to hold the Cable in the groove Pulley Find the Butterfly Cable 85-this isTrap must be oriented as shown and be End with Two holes Should be Down Cable Assembly Post Wide Tabs Must be On this Side Cable Assembly Cable Assembly Cable must be routed from the direction shown Find the Press Cable 88. Attach the end Plates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceLocknut until step Cable Assembly Seat Assembly Seat AssemblySeat Assembly High Pulley HOW to USE the Home GYM System Changing the Weight SettingAttaching the AB Strap to the AB Pulley Station Adjusting the LEG LeverAdjusting the LEG Press Plate Weight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesButterfly Cable Left Arm Right Arm Cable DiagramsPress Cable High Cable Long U Bracket Leg Press-13 Page Page X 3 1/4 Bolt Part LIST-Model No Qty DescriptionExploded DRAWING-Model No R0499AQUESTIONS?