CABLE ASSEMBLY
36.Route the Press Cable (88) over the indicated 3 1/2” Pulley (82) attached to the Pulley Plates (31). The Cable must be routed from the direction shown. Refer to the inset draw- ing. Be sure that the Cable is between the
Cable Trap (80) and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.
37.Wrap the Rear Cable (87) around a 3 1/2” Pulley (82). Attach the Pulley and a Cable Trap (80) to the Ab Upright (1) with a 3/8” x 3 1/2” Bolt (66), a 3/8” Washer (38) and a 3/8” Jam Nut (43). Be sure that the Cable and
Pulley move smoothly and that the Cable is between the Pulley and the post.
36 |
|
| 31 |
| 50 |
| 82 |
| 87 |
80 |
|
87 |
|
37 |
|
66 | 80 |
| 1 |
| 82 |
87 | 38 |
| |
| 43 |
17