Weider 831.159290 user manual Plates 31. The Cable must be routed from

CABLE ASSEMBLY

48. Note: The 3 1/2” Pulley (82) in this step is	48
pre-assembled. It is shown dis-assembled
for easier part identification.
Route the Press Cable (88) around the 3 1/2”			88	80
Pulley (82) attached to the indicated bracket
				42
on the Press Base (13). Be sure that the		82
Cable is in the groove of the Pulley and
that the Cable Trap (80) is turned as shown
to hold the Cable in place. Tighten the 3/8”
x 2” Bolt (50) and the 3/8” Nylon Locknut (42).
	50	13
49. Route the Press Cable (88) over the indicated	49
3 1/2” Pulley (82) attached to the Pulley
Plates (31). The Cable must be routed from				31
the direction shown. Refer to the inset draw-
ing. Be sure that the Cable is between the				50
Cable Trap (80) and the Pulley, and that the
		88		82
Cable Trap is positioned to hold the Cable
in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8”					80
				88
Nylon Locknut (not shown).
50. Wrap the Press Cable (88) around a 3 1/2”	50
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the Leg Press Upright (4) with a
3/8” x 3 1/2” Bolt (66), a 3/8” Washer (38) and
a 3/8” Nylon Jam Nut (43). Be sure that the				4
Cable Trap is turned to hold the Cable in
place.				38	43
		88
		82
	66	80
51. Wrap the Press Cable (88) around a 3 1/2”	51
Pulley (82). Attach the Pulley and a Cable
Trap (80) to the indicated hole in the Press					42
Frame (12) with a 3/8” x 3 1/2” Bolt (66), a
3/8” Washer (38) and a 3/8” Nylon Locknut
(42). Be sure that the Cable Trap is turned
to hold the Cable in place.					80
				82
	88	66	38
			12

21