Weider 831.159290 user manual Cable Assembly Seat Assembly

CABLE ASSEMBLY

SEAT ASSEMBLY

56. Wrap the Press Cable (88) around a “V”	56	83
Pulley (81). Attach the “V” Pulley and a Large
Cable Trap (83) to the bracket on the Front		65
Seat Frame (8) with a 3/8” x 2 1/2” Bolt (65)
and a 3/8” Nylon Locknut (42). Be sure that		81
the Large Cable Trap is turned to hold the
Cable in place and that the Cable and
Pulley move smoothly.
			8
		88
		42
57. Note: The 3 1/2” Pulley (82) used in this	57
step was attached in step 55. It is shown
removed for easier part identification.
Route the Press Cable (88) around the 3 1/2”
Pulley (82). Be sure that the Cable Trap (80)		9	43
is turned to hold the Cable in place and
that the Cable is routed as shown. Tighten			82
the 3/8” x 4 1/2” Bolt (74) and the 3/8” Nylon
Jam Nut (43).			80
			88
		74
58. Slide a 5/16” Washer (20) onto a 5/16” x 2 3/4”	58
Bolt (55). Insert the Bolt into the Front Seat
Frame (8). Fully tighten a 5/16” Nylon Jam
Nut (91) onto the Bolt. Slide the end of the
Press Cable (88) onto the Bolt. Thread anoth-
er 5/16” Nylon Jam Nut (91) onto the Bolt, but
do not fully tighten it. Leave enough room			88
between the two Jam Nuts for the Cable to		8
pivot.
			91
		20
		55
59. Locate and open the parts bag labeled	59	4
“SEAT ASSEMBLY.”
Attach the Large Backrest (19) to the Leg
Press Upright (4) with two 1/4” x 2 1/2”
Machine Screws (64) and two 1/4” Washers			19
(37).		64 37
23