Weider 831.159290 user manual Cable Assembly

CABLE ASSEMBLY

29.Note: The 3 1/2” Pulley (82) in this step is pre-assembled. It is shown removed for easier part identification.

Locate the High Cable (86)—this is the shortest remaining Cable. Route the High Cable around the 3 1/2” Pulley (82) attached to the Top Frame (2). Be sure that the end of the Cable with the ball is on the indicated side of the Pulley and that the Cable is between the Pulley and the post. Tighten the 3/8” x 3 1/2” Bolt (66) and the 3/8” Nylon Locknut (42), with the 3/8” Washer (38).

30.Wrap the High Cable (86) around a 3 1/2” Pulley (82). Attach the Pulley and a Cable Trap (80) to the Top Frame (2) with a 3/8” x

3 1/2” Bolt (66), a 3/8” Washer (38) and a 3/8” Nylon Jam Nut (43). Be sure that the Cable

Trap is positioned to hold the Cable in place.

31.Locate the remaining pre-assembled pair of Pulley Plates (31) and 3 1/2” Pulleys (82).

Route the High Cable (86) under the indicated 3 1/2” Pulley (82). The end of the Pulley Plates (31) with two holes should be down- ward. Refer to the inset drawing. Be sure that the Cable is between the Cable Trap

(80)and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.

Tighten the 3/8” x 2” Bolt (50) and the 3/8” Nylon Locknut (not shown).

32.Wrap the High Cable (86) around a 3 1/2” Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). The Cable must be routed from the direction shown.

29
	2
	38
42
		82
Post
	86	66
30
66	38
2		80
	82	43
		86
31
86		86
50	82
31
End with two		80
holes should
be down
32	42
2		50
		82
		86

15