19.Route the Swivel High Cable (74) throughthe Swivel Upright (5) and over a 4 1/2" Pulley (119). Attach the Pulley inside the Updghtwith a 3/8" x 2 3/4" Bolt (101), two 3/8" Washers (91), two 1/2" Spacers (89), and a 318"Nylon Locknut(87).
Attach a 318"x 2 112"Bolt (18), two 3/8" Washers (91), and a 3/8" Nylon Locknut(87) to the Swivel Upright (5).
20.Remove the preettached 3 1/2" Pulleys (78) from the Small Pulley Plates (31).
Wrap the Swivel High Cable (74) over a 3 112" Pulley (78). Attach the Pulley and a Cable Trap (68) to the second set of holes from the top of the Small Pulley Plates (31) with a 3/8" x 2" Bolt (100) and a 3/8" Nylon Locknut (87). Make sure the Cable
Trap Is turned to hold the Cable In the groove of the Pulley.
21.Wrap the Swivel High Cable (74) over a 4 112" Pulley (119). Attach the Pulley inside of the indicat- ed bracket on the Top Frame (6) with 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon Locknut (87).
22.Lift the Weight Tube (43) and the Top Weight (45) closestto the Swivel Upright(5). Make sure that the small pin on the Weight Tube is inside of the groove under the Top Weight.
Insert a Weight Pin (50) into the stack of Weights
(44). Place a 1/2" Washer (1) on top of the Weight Tube (43). "tightena 1/2" Nut (118) halfway onto the end of the Swivel High Cable (74). Screw the end of the Cable two full turnsinto the Weight Tube. Then, tighten the Nut againstthe 1/2" Washer.
23.Locate the Swivel Cable (17), which Is 115 3/'8" long and has an eyelet on each end. Attach the
Cable inside the Top Frame (6) with a 5/16" x 2 112" Bolt (59), two 5/16" Washers (90), and a 5/16" Nylon Locknut (86).
19
5 91 18
91_x_'__01
87_149 74
2O
31
31
21
93
22
23
59
90 86
,.17
12