53.Wrap the Squat Cable (73) under a 3 1/2" Pulley
(78).Attach the Pulley and a Cable Trap to the sec- ond set of holes from the top in the indicated brack- et on the Long Base (120) with a 3/8" x 2" Bolt
(100)and a 318"Nylon Locknut (87). Make sure that the Cable Trap Is turned to hold the Cable In the groove of the Pulley.
54.Wrap the Squat Cable (73) over a 4 1/2" Pulley (119). Attach the Pulley to the indicatedbracket on
the Top Frame (6) with a 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon Locknut (87).
55.Place a 1/2" Washer (1) on top of the Weight Tube
(43)closestto the Squat Upright(4). Tighten a 1/2" Nut (118) halfway onto the end of the Squat Cable
Lift the Weight Tube (43) and the Top Weight (45) and make sure that the small pin on the Weight
Tube is inside of the groove under the Top Weight.
Hold the Weight Tube (43) and the Top Weight (45)
afew inches over the weight stack and insert the
Weight Pin (50). Screw the end of the Cable (73) two full turns intothe Weight Tube. Then, tightenthe
Nut againstthe 1/2" Washer (1). Remove the Weight
Pin and set the Top Weight back on the weight stack. Replace the Pin.
56
100120
6
87
./
56. Locate and open the parts bag labeled "SEAT
ASSEMBLY."
1
Insert the Pad Tube (23) into the square hole in the Seat Upright (9). Slide the two Knee Pads (19) onto the Pad Tube as shown. Press the two Knee Pad Caps (109) into the ends of the Pad Tube.
| 20 |
|
Slide two Short Pads (20) onto the Leg Lever (10). | 10 | 109 |
|
19