39.Route the Leg Lever Cable (75) under a 4 112" Pulley (119). Attach the Pulley and a Large Cable Trap (121) to the indicated side oi the Buttedly Upright (3) with a 3/8" x 3 3/4" Bolt (122), a 3/8" Washer (91), and a 3/8" Nylon Jamnut (113). Make sure that the Large Cable Trap Is turned to hold the Cable In the groove of the Pulley.
40. Wrap the Leg Lever Cable (75) over a 3 1/2" Pulley | l0 | |
(78). Attach the Pulley to the Double | ||
|
(62)with a 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon Locknut (87).
113
I
41, Remove the preattached 3 1/2" Pulley (not shown) from the
FI
II II
Attach the end of the Leg Lever Cable (75) to the
tighten the Locknut; It should be threaded only two turns onto the end of the Cable.
J
97
42.Locate the Swivel Low Cable (72), which Is the only remaining cable that has an eyelet on one end and a ball on the other end. Route the eyelet and of the Cable through the cage on the Long Base (120) and through the Swivel Upright (5) as shown.
Attach a 3 1/2" Pulley (78) to the indicatedbracket on the Long Base (120) with 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon Locknut (87).
43.Wrap the Swivel Low Cable (72) under a 3 112" Pulley (78). Attach the Pulleyto the indicatedbrack- et on the Long Base (120) with a 3/8" x I 3/4" Bolt
(93)and a 3/8" Nylon Locknut (87).
\J
42
93
43
J
16