34.Remove the preettached 3 1/2" Pulleys (78) from the Double
Wrap the ButterflyCable (69) under a 3 1/2" Pulley
(78).Attach the Pulley to the Double
(62)with a 3/8" x 1 3/4" Bolt (93) and a 3/8" Nylon Locknut (67).
35.Wrap the Butterfly Cable (69) over a
Attach the Pulley and a Long Cable Trap (102) to the other bracket on the Butterfly Upright (3) with a 318"x 2 1/2" Bolt (18) and a 3/8" Nylon Locknut
(87).Make sure that the Long Cable Trap Is
turned to hold the Cable In the groove of the Pulley.
36.Attach the ButterflyCable (69) to the Pivot Bracket
(70)on the Right ButterflyArm (26) with a 5/16" x 1" Shoulder Bolt (103) and a 5/16" Nylon Locknut (86).
37.Locate the Leg Lever Cable (75), which Is 98 1/2" long and has an eyelet on one end end e thread- ed pin on the other end. Route the eyelet end of the Cable through the Seat Upright (9) and attach it to the tab on the Leg Lever (10) with a 5/16" x 1" Shoulder Bolt (103) and a 5/16" Nylon Locknut (86).
38. Attach a 3 1/2" Pulley (78) inside of the Seat | 38 | ||
Upright (9) with a 3/8" x 2 3/4" Bolt (101), two 3/8" | |||
| |||
Washers (91), two 1/2" Spacers | (89), and a 3/8" | 91 | |
Nylon Looknut (87), as shown. |
|
,101
89
15