Miele PW 6161, PW 6101, PW 6131, PW 6201 Detergent, Fabric softener, Dosage, Water hardness

Page 12

Use

Detergent

Only use the correct amount of high efficiency low sudsing detergent. Too much detergent will cause oversudsing.

Dosage

Follow the instructions on the detergent packaging to ensure the correct usage and dosage amount for your water hardness.

Adjust the amount of detergent if the load is smaller and more or less soiled than normal.

Water hardness

Water

Water

Hardness

German

hardness

quality

level in

hardness

levels

 

mmol/l

°d

I

soft

0 - 1.3

0 - 7

 

 

 

 

II

moderate

1.3 - 2.5

7 - 14

 

 

 

 

III

hard

2.5 - 3.8

14 - 21

 

 

 

 

IV

very hard

over 3.8

over 21

 

 

 

 

If you do not know the water hardness in your area contact your local water authority.

Fabric softener

^Pour liquid fabric softener into the compartment according to the manufacturer’s instructions. Do not exceed the maximum fill level, the excess will prematurely activate the siphon and be wasted.

^Close the compartment lid and push in the dispenser drawer.

The fabric softener will automatically be dispensed during the final rinse cycle.

A small amount of water will remain in the compartment at the end of the program.

Never mix fabric softener and starch in the fabric softener compartment §. This will clog the dispenser.

12

Image 12
Contents Operating Instructions Washer Contents Contents Important Safety Instructions Correct usage of the washerElectrical Safety Grounding InstructionsUsing accessories UseAdditional information Guide to the washer Detergent compartmentsControl panel Emergency Stop button Drum door e Door handleOperating panel Control keys Operator CardUse Turn on the washerSort and load the laundry Maximum dry laundry weights Add detergent§ = Front compartment Rear compartmentDetergent Fabric softenerDosage Water hardnessStarch BleachFabric dye Detergent containerSelect a program Select wash options if needed+ i Block Plus Starch StopSelect Delay Start if needed Adjust the program if neededStart the program End of programSpin speed Do not use forceCanceling a program Canceling a locked programSkipping program cycles Program sequenceTo go back without skipping a program cycle Information Program end with water in the drumProgram stop Program Guide Standard Programs Program Fabric Program cycleWarm rinse Washing using the program card Card only operationExtra features Language selectionOptional modules Liquid dispensing systemPriming the dispensing pumps Deselect the dispensingMaintenance of the dispensing system Dispensing calibrationPeak load cut off PC ConnectionLoad size Cleaning and Care Cleaning the exteriorAfter each use Maintenance during downtime Vent grilleRust Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Frequently asked questions Safety mechanism of the door handle is disengagedReasons for oversudsing Drum door cannot be openedPower failure Emergency door release During a short power failureExtended power failure Draining the wash waterDisplay Service interval Fault messagesCheck the water supply and press h Start After sales service Guide to the data plate symbols Noise levelPage Installation Instructions Help to protect the environment Disposal of the packing materialsDisposal of an old appliance Installation Instructions Installation siteRemoving the shipping struts Connecting the water intake / water drain hoses PlumbingCold water connection only Connecting the dispensing pumps Electrical connectionSteam connection Quick Guide All rights reserved 06 578 520