Miele PW 6131 Select a program, Select wash options if needed, + i Block Plus, Starch Stop

Page 14

Use

4. Select a program

^Select a program by turning the jog shuttle (e.g. Program 1 Hot Wash).

The following will appear in the display:

16

Extra Drain

 

1

Hot Wash

194 °F

2

Cottons

140 °F

i

ä FC

A

^See the Programming manual for more information.

^Confirm the selected program by pressing the inner button of the jog shuttle.

The display shows:

1

Hot Wash

 

22.0 /22.0 lb

194 °F

Main wash

 

 

 

Rinse

 

1200 rpm

+i

m k

m

A

5. Select wash options (if needed)

^Press one of the wash option buttons. To deselect the option, press it again.

+ i Block Plus

A pre-wash can be selected for heavily soiled laundry in certain programs. If a pre-wash is an option the "+i" field is highlighted. If a pre-wash is not available, the "+i" will not be shown.

m Starch Stop

Starch can be selected with all standard programs (excluding Extra Spin and Extra Drain). The m field is highlighted in the display.

k Spin Stop

Spin Stop can be selected with all standard programs (excluding Extra Spin). The k field is highlighted in the display.

1

Hot Wash

k

Program stop - w/o spin

Door can be opened.

 

i

ü

f

"Without spin" flashes in the display when the spin cycle is reached.

^Press the f "End" button.

^The program ends without spinning.

^To continue the program with spinning, press the h "Start" button.

14

Image 14
Contents Operating Instructions Washer Contents Contents Important Safety Instructions Correct usage of the washerElectrical Safety Grounding InstructionsAdditional information Using accessoriesUse Control panel Emergency Stop button Guide to the washerDetergent compartments Drum door e Door handleOperating panel Control keys Operator CardSort and load the laundry UseTurn on the washer § = Front compartment Maximum dry laundry weightsAdd detergent Rear compartmentDosage DetergentFabric softener Water hardnessFabric dye StarchBleach Detergent container+ i Block Plus Select a programSelect wash options if needed Starch StopSelect Delay Start if needed Adjust the program if neededSpin speed Start the programEnd of program Do not use forceCanceling a program Canceling a locked programTo go back without skipping a program cycle Skipping program cyclesProgram sequence Program stop InformationProgram end with water in the drum Program Guide Standard Programs Program Fabric Program cycleWarm rinse Washing using the program card Card only operationExtra features Language selectionPriming the dispensing pumps Optional modulesLiquid dispensing system Deselect the dispensingMaintenance of the dispensing system Dispensing calibrationLoad size Peak load cut offPC Connection After each use Cleaning and CareCleaning the exterior Rust Maintenance during downtimeVent grille Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Reasons for oversudsing Frequently asked questionsSafety mechanism of the door handle is disengaged Drum door cannot be openedExtended power failure Power failure Emergency door releaseDuring a short power failure Draining the wash waterDisplay Service interval Fault messagesCheck the water supply and press h Start After sales service Guide to the data plate symbols Noise levelPage Installation Instructions Disposal of an old appliance Help to protect the environmentDisposal of the packing materials Installation Instructions Installation siteRemoving the shipping struts Cold water connection only Connecting the water intake / water drain hosesPlumbing Steam connection Connecting the dispensing pumpsElectrical connection Quick Guide All rights reserved 06 578 520