Miele PW 6161, PW 6101, PW 6131 Start the program, End of program, Spin speed, Do not use force

Page 16

Use

Spin speed

The spin speed can be adjusted from 0 - 300 then in 25 rpm increments. Depending on the model of machine and the Program selected the max. spin speed ranges from 600 - 1200 rpms.

^Turn the jog shuttle to "Spin speed" and press to confirm the selection.

1

Hot Wash

22.0 /

22.0 lb

 

Rinse

1200 rpm

-

 

 

 

 

+i

m k m

 

A

^Turn the jog shuttle to the desired spin speed and press to confirm the selection.

8. Start the program

^Press the h "Start" button to start the program.

9. End of program

At the end of the program, once the drum is stationary and no water is in the machine the display shows (for example):

1Hot Wash

Program end

Door can be opened.

m FC

A

At the same time a tone will sound for a short time to signal the program end.

^Pull the door handle to open the drum door.

Important:

If the door cannot be opened, press against the door handle then pull again.

Do not use force!

^Remove the laundry.

^Leave the drum door open to air dry the interior.

^Turn the machine off with the 0 "Off" button.

^Turn the mains off (on-site).

^Close the gas or steam valve (on-site).

16

Image 16
Contents Operating Instructions Washer Contents Contents Important Safety Instructions Correct usage of the washerElectrical Safety Grounding InstructionsUse Using accessoriesAdditional information Guide to the washer Detergent compartmentsControl panel Emergency Stop button Drum door e Door handleOperating panel Control keys Operator CardTurn on the washer UseSort and load the laundry Maximum dry laundry weights Add detergent§ = Front compartment Rear compartmentDetergent Fabric softenerDosage Water hardnessStarch BleachFabric dye Detergent containerSelect a program Select wash options if needed+ i Block Plus Starch StopSelect Delay Start if needed Adjust the program if neededStart the program End of programSpin speed Do not use forceCanceling a program Canceling a locked programProgram sequence Skipping program cyclesTo go back without skipping a program cycle Program end with water in the drum InformationProgram stop Program Guide Standard Programs Program Fabric Program cycleWarm rinse Washing using the program card Card only operationExtra features Language selectionOptional modules Liquid dispensing systemPriming the dispensing pumps Deselect the dispensingMaintenance of the dispensing system Dispensing calibrationPC Connection Peak load cut offLoad size Cleaning the exterior Cleaning and CareAfter each use Maintenance during downtime Vent grilleRust Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Frequently asked questions Safety mechanism of the door handle is disengagedReasons for oversudsing Drum door cannot be openedPower failure Emergency door release During a short power failureExtended power failure Draining the wash waterDisplay Service interval Fault messagesCheck the water supply and press h Start After sales service Guide to the data plate symbols Noise levelPage Installation Instructions Disposal of the packing materials Help to protect the environmentDisposal of an old appliance Installation Instructions Installation siteRemoving the shipping struts Plumbing Connecting the water intake / water drain hosesCold water connection only Electrical connection Connecting the dispensing pumpsSteam connection Quick Guide All rights reserved 06 578 520