Miele PW 6101, PW 6161, PW 6131, PW 6201 Plumbing, Connecting the water intake / water drain hoses

Page 41

Installation Instructions

Plumbing

The machine should be connected to two water supply valves, which conform with local and national regulations. Installation must be carried out by an authorized service technician.

To ensure the machine is correctly connected please follow the installation plan and the separate installation instructions supplied with the machine.

Connecting the water intake / water drain hoses

See the enclosed installation plan.

A water pressure flow rate of at least 14.5 psi, maximum 145 psi is required.

The inlet pressure hoses supplied with the machine must be used for connection to the water supply.

The hoses should only be replaced with genuine Miele spare parts which fulfill the pressure requirements.

The hot water intake must not exceed a temperature of 158°F (70°C).

Cold water connection only

See the enclosed installation diagram.

,Must comply with all local codes.

41

Image 41
Contents Operating Instructions Washer Contents Contents Correct usage of the washer Important Safety InstructionsGrounding Instructions Electrical SafetyAdditional information Using accessoriesUse Detergent compartments Guide to the washerControl panel Emergency Stop button Drum door e Door handleOperating panel Operator Card Control keysSort and load the laundry UseTurn on the washer Add detergent Maximum dry laundry weights§ = Front compartment Rear compartmentFabric softener DetergentDosage Water hardnessBleach StarchFabric dye Detergent containerSelect wash options if needed Select a program+ i Block Plus Starch StopAdjust the program if needed Select Delay Start if neededEnd of program Start the programSpin speed Do not use forceCanceling a locked program Canceling a programTo go back without skipping a program cycle Skipping program cyclesProgram sequence Program stop InformationProgram end with water in the drum Program Fabric Program cycle Program Guide Standard ProgramsWarm rinse Card only operation Washing using the program cardLanguage selection Extra featuresLiquid dispensing system Optional modulesPriming the dispensing pumps Deselect the dispensingDispensing calibration Maintenance of the dispensing systemLoad size Peak load cut offPC Connection After each use Cleaning and CareCleaning the exterior Vent grille Maintenance during downtimeRust Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Safety mechanism of the door handle is disengaged Frequently asked questionsReasons for oversudsing Drum door cannot be openedDuring a short power failure Power failure Emergency door releaseExtended power failure Draining the wash waterFault messages Display Service intervalCheck the water supply and press h Start After sales service Noise level Guide to the data plate symbolsPage Installation Instructions Disposal of an old appliance Help to protect the environmentDisposal of the packing materials Installation site Installation InstructionsRemoving the shipping struts Cold water connection only Connecting the water intake / water drain hosesPlumbing Steam connection Connecting the dispensing pumpsElectrical connection Quick Guide All rights reserved 06 578 520