Miele PW 6101, PW 6161, PW 6131, PW 6201 Electrical Safety, Grounding Instructions

Page 5

IMPORTANT SAFETY INSTRUCTIONS

Electrical Safety

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current.

Repairs to electrical or steam appliances should only be carried out by a Miele

authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or machine damage. The manufacturer cannot be held responsible for unauthorized work.

Do not repair of replace any part of the appliance or attempt any servicing

unless specifically recommended in these operating instructions. Contact Miele’s Technical Service Department for assistance.

Do not damage, remove, or bypass any of the safety features and controls of the

washer.

Do not operate a machine with an electrical fault until repaired.

Only use the washer if all panels are properly in place.

The washer is only completely isolated from the electrical supply when the

circuit breaker has been tripped or the power main shut off.

Do not use force to open the washer drum door. The door handle is equipped

with an extra safety mechanism to guarantee that the door remains locked.

Faulty components must only be replaced with genuine Miele spare parts

to guarantee the safe operation of this machine.

5

Image 5
Contents Operating Instructions Washer Contents Contents Correct usage of the washer Important Safety InstructionsGrounding Instructions Electrical SafetyAdditional information Using accessoriesUse Detergent compartments Guide to the washerControl panel Emergency Stop button Drum door e Door handleOperating panel Operator Card Control keysSort and load the laundry UseTurn on the washer Add detergent Maximum dry laundry weights§ = Front compartment Rear compartmentFabric softener DetergentDosage Water hardnessBleach StarchFabric dye Detergent containerSelect wash options if needed Select a program+ i Block Plus Starch StopAdjust the program if needed Select Delay Start if neededEnd of program Start the programSpin speed Do not use forceCanceling a locked program Canceling a programTo go back without skipping a program cycle Skipping program cyclesProgram sequence Program stop InformationProgram end with water in the drum Program Fabric Program cycle Program Guide Standard ProgramsWarm rinse Card only operation Washing using the program cardLanguage selection Extra featuresLiquid dispensing system Optional modulesPriming the dispensing pumps Deselect the dispensingDispensing calibration Maintenance of the dispensing systemLoad size Peak load cut offPC Connection After each use Cleaning and CareCleaning the exterior Vent grille Maintenance during downtimeRust Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Safety mechanism of the door handle is disengaged Frequently asked questionsReasons for oversudsing Drum door cannot be openedDuring a short power failure Power failure Emergency door releaseExtended power failure Draining the wash waterFault messages Display Service intervalCheck the water supply and press h Start After sales service Noise level Guide to the data plate symbolsPage Installation Instructions Disposal of an old appliance Help to protect the environmentDisposal of the packing materials Installation site Installation InstructionsRemoving the shipping struts Cold water connection only Connecting the water intake / water drain hosesPlumbing Steam connection Connecting the dispensing pumpsElectrical connection Quick Guide All rights reserved 06 578 520