Miele PW 6161, PW 6101, PW 6131, PW 6201 Display Service interval, Fault messages

Page 32

Frequently asked questions

Display Service interval

^Call Technical Service for maintenance if the display shows the following message after turning the machine on.

§	Service interval 1
	Call the Miele Service Department.

A

The display goes out after 5 seconds.

Fault messages

,Repairs to electrical or steam appliances should only be carried out by a Miele authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or machine damage. The manufacturer cannot be held responsible for unauthorized work.

Faults that occur before or after the start of a program flash in the display.

If the display remains off, the dryer has no power.

^Check the plug, main switch and fuses on-site.

y	Power failure
y	Program stop
	Press Start.

f

^Press h "Start".

This fault message can also indicate that the overload cut-out of the drive motors has over heated.

^Allow the motor to cool.

32

Image 32

Contents Operating Instructions Washer Contents Contents Important Safety Instructions Correct usage of the washerElectrical Safety Grounding InstructionsAdditional information Using accessoriesUse Guide to the washer Detergent compartmentsControl panel Emergency Stop button Drum door e Door handleOperating panel Control keys Operator CardSort and load the laundry UseTurn on the washer Maximum dry laundry weights Add detergent§ = Front compartment Rear compartmentDetergent Fabric softenerDosage Water hardnessStarch BleachFabric dye Detergent containerSelect a program Select wash options if needed+ i Block Plus Starch StopSelect Delay Start if needed Adjust the program if neededStart the program End of programSpin speed Do not use forceCanceling a program Canceling a locked programTo go back without skipping a program cycle Skipping program cyclesProgram sequence Program stop InformationProgram end with water in the drum Program Guide Standard Programs Program Fabric Program cycleWarm rinse Washing using the program card Card only operationExtra features Language selectionOptional modules Liquid dispensing systemPriming the dispensing pumps Deselect the dispensingMaintenance of the dispensing system Dispensing calibrationLoad size Peak load cut offPC Connection After each use Cleaning and CareCleaning the exterior Maintenance during downtime Vent grilleRust Water inlet filtersDrum bearing lubrication PW 6161 and 6201 only Frequently asked questions Safety mechanism of the door handle is disengagedReasons for oversudsing Drum door cannot be openedPower failure Emergency door release During a short power failureExtended power failure Draining the wash waterDisplay Service interval Fault messagesCheck the water supply and press h Start After sales service Guide to the data plate symbols Noise levelPage Installation Instructions Disposal of an old appliance Help to protect the environmentDisposal of the packing materials Installation Instructions Installation siteRemoving the shipping struts Cold water connection only Connecting the water intake / water drain hosesPlumbing Steam connection Connecting the dispensing pumpsElectrical connection Quick Guide All rights reserved 06 578 520