Miele PW 6201, PW 6161, PW 6101 Information, Program end with water in the drum, Program stop

Page 19

Use

KInformation

1	Hot Wash
194 °F	Main wash				140 °F
	Rinse 1		Cold	End at 12:35
+i	m	k	m	K	f

Press the K "Information" button during the program to show information in the display.

1	Hot Wash
Delay start: 10.7.2003

Start time: 9:47		e
		A

For more information press e.

Time after start: 0 h 23 min
Time left: 0 h 11min
Time after start: 0 h 23 min		e

Time left: 0 h 11min
Repetition: no
Area: Rinse 3		e

Block 2: Rinse	2
Block step Wash time 1
Actual water level: 22 mm		e

Programmed value: 60 mm
Actual temperature: 95°F
Programmed temperature: 140 °F		e

1Hot Wash Revolution: 40 rpm

Rhythm: 12 / 3	-
	A

^Press the A "Back" button to return to the program sequence.

Program end with water in the drum

If the program is interrupted during a cycle, the display shows either:

1 Hot Wash

Program end - Water in drum

m FC

A

or

1 Hot Wash

Program end - Drum not stationary

m FC

A

,The drum door is locked.

Do not use force!

^Press the q "Water drain" button or select the Drain Extra and press h "Start".

^At the end of the program open the door.

Program stop

^To stop the program, press f "End". The program stops.

1Hot Wash

Program stop

i ü

f

^Press f "End" again to continue the program.

19

Image 19

Contents Operating Instructions Washer Contents Contents Correct usage of the washer Important Safety InstructionsGrounding Instructions Electrical SafetyUse Using accessoriesAdditional information Drum door e Door handle Guide to the washerDetergent compartments Control panel Emergency Stop buttonOperating panel Operator Card Control keysTurn on the washer UseSort and load the laundry Rear compartment Maximum dry laundry weightsAdd detergent § = Front compartmentWater hardness DetergentFabric softener DosageDetergent container StarchBleach Fabric dyeStarch Stop Select a programSelect wash options if needed + i Block PlusAdjust the program if needed Select Delay Start if neededDo not use force Start the programEnd of program Spin speedCanceling a locked program Canceling a programProgram sequence Skipping program cyclesTo go back without skipping a program cycle Program end with water in the drum InformationProgram stop Program Fabric Program cycle Program Guide Standard ProgramsWarm rinse Card only operation Washing using the program cardLanguage selection Extra featuresDeselect the dispensing Optional modulesLiquid dispensing system Priming the dispensing pumpsDispensing calibration Maintenance of the dispensing systemPC Connection Peak load cut offLoad size Cleaning the exterior Cleaning and CareAfter each use Water inlet filters Maintenance during downtimeVent grille RustDrum bearing lubrication PW 6161 and 6201 only Drum door cannot be opened Frequently asked questionsSafety mechanism of the door handle is disengaged Reasons for oversudsingDraining the wash water Power failure Emergency door releaseDuring a short power failure Extended power failureFault messages Display Service intervalCheck the water supply and press h Start After sales service Noise level Guide to the data plate symbolsPage Installation Instructions Disposal of the packing materials Help to protect the environmentDisposal of an old appliance Installation site Installation InstructionsRemoving the shipping struts Plumbing Connecting the water intake / water drain hosesCold water connection only Electrical connection Connecting the dispensing pumpsSteam connection Quick Guide All rights reserved 06 578 520