Miele Power Failure and Emergency Door Release Instructions for Washers

Page 31

Frequently asked questions

Power failure - Emergency door release

During a short power failure

The program remains in the last position. When power is restored the following message appears in the display:

y

Power failure

Program stop

 

Press Start.

f

^Press h "Start" to continue the program.

Extended power failure

^Turn the machine off.

^Turn the electrical supply off at the mains.

^Close the steam valve (on-site).

The machine must be drained and the drum door opened manually to unload the machine.

Draining the wash water

^Place a container under the manual drain at the rear of the machine.

^Open the drain by loosening the venting screw. Do not take it completely out.

^A small amount of water from the machine will drain.

^Tighten the venting screw again and test for leaks by opening the water supply.

Open the door manually

^Insert and hold a small screwdriver in the opening next to the door lock.

^Press against the door handle, then pull it towards you to open the door.

Do not use force!

^Remove the laundry.

31

Image 31
Contents Operating Instructions Washer Contents Contents Correct usage of the washer Important Safety InstructionsGrounding Instructions Electrical SafetyUse Using accessoriesAdditional information Drum door e Door handle Guide to the washerDetergent compartments Control panel Emergency Stop buttonOperating panel Operator Card Control keysTurn on the washer UseSort and load the laundry Rear compartment Maximum dry laundry weightsAdd detergent § = Front compartmentWater hardness DetergentFabric softener DosageDetergent container StarchBleach Fabric dyeStarch Stop Select a programSelect wash options if needed + i Block PlusAdjust the program if needed Select Delay Start if neededDo not use force Start the programEnd of program Spin speedCanceling a locked program Canceling a programProgram sequence Skipping program cyclesTo go back without skipping a program cycle Program end with water in the drum InformationProgram stop Program Fabric Program cycle Program Guide Standard ProgramsWarm rinse Card only operation Washing using the program cardLanguage selection Extra featuresDeselect the dispensing Optional modulesLiquid dispensing system Priming the dispensing pumpsDispensing calibration Maintenance of the dispensing systemPC Connection Peak load cut offLoad size Cleaning the exterior Cleaning and CareAfter each use Water inlet filters Maintenance during downtimeVent grille RustDrum bearing lubrication PW 6161 and 6201 only Drum door cannot be opened Frequently asked questionsSafety mechanism of the door handle is disengaged Reasons for oversudsingDraining the wash water Power failure Emergency door releaseDuring a short power failure Extended power failureFault messages Display Service intervalCheck the water supply and press h Start After sales service Noise level Guide to the data plate symbolsPage Installation Instructions Disposal of the packing materials Help to protect the environmentDisposal of an old appliance Installation site Installation InstructionsRemoving the shipping struts Plumbing Connecting the water intake / water drain hosesCold water connection only Electrical connection Connecting the dispensing pumpsSteam connection Quick Guide All rights reserved 06 578 520