Miele T 220 How to dry correctly, Prepare the laundry, Load the drum Switch on the dryer

Page 14

How to dry correctly

Prepare the laundry

^As far as possible, sort laundry for:

-the type of fibre or weave,

-the degree of dryness required,

-similar size of items,

-the moisture content after

spinning.

This will help towards achieving an even drying result.

Fasten duvet covers etc. to prevent small items from being rolled up inside them.

Do up zips, hooks and eyes etc.

Tie fabric belts, apron strings.

Sew in or remove underwiring from bras.

Make sure there is no detergent dis- penser ball etc. in with the laundry, as this could melt and damage the machine and the laundry.

Load the drum

and switch on the dryer

^Press the door button and open the door.

^Load the laundry loosely into the drum.

Do not overload the drum. Over- loading can cause unecessary wear and tear to the laundry and give a disappointing drying result.

See the "Programme chart" for maxi- mum recommended loads.

^Before closing the door check that the fluff filter is correctly positioned in the door.

When closing the door make sure items of laundry cannot be trapped by the door, as this will cause dam- age to the laundry.

^Shut the door either with a gentle swing or lean against it and push it shut.

^Switch the dryer on by pressing the "l-On/0-Off" button.

14

Image 14
Contents Operating instructions for vented tumble dryer T Contents Consumption data Technical data Technical safety Correct useOperation Page Using accessories Disposal of your old appliance Caring for the environmentDisposal of the packing material Energy saving tipsProgramme sequence and check lamps Start button Control panelProgramme selector Door buttonTips on drying Wash care labelsNormal+ Low temperatureProgrammes Fabric type Special notes NormalProgramme chart Minimum IronWarm air Hand careSmoothing Cool airPrepare the laundry How to dry correctlyLoad the drum Switch on the dryer Select a programme Start the programmeSelecting a different programme To cancel a programmeAt the end of a programme Interrupting a programmeTumble dryer Cleaning and careCleaning the fluff filter Problem solving guide Laundry is not suffi Problem Possible cause Remedy There is a build upFluff Ciently dryGoes on too long or Problem Possible cause Remedy Drying processEven switches off Tons or Minimum Iron programme. If the drum is Programme againTo change the interior drum lamp Repairs After sales servicePC indicator lamp Interface for service technicians Installation Front viewAligning the machine InstallationTransporting the machine to its installation site Washer-dryer stack Installation siteReplacing the lid Electrical connection General Installation ventingProcedure AvoidInternal duct diameter Calculating the effective duct lengthTo calculate the effective duct length Left or right side of the machine Calculation exampleAt the rear Venting systems overview Venting system with Flexible ducting hoseInstallation examples venting sys- tem with flexible hose Venting system with plastic piping ExampleConnecting directly to a wall vent Main venting duct Washer dryer stack Height of venting outlet for washer dryer stackConsumption data CottonsTechnical data Programmable functions for changing standard settings Increased drying level in the Cottons programmes Is switched onProgrammable functions To checkIncreased drying level in the Minimum Iron programmes Buzzer