Installation
Installation site
Building under a continuous work- top / in a row of kitchen units
The space required by the vent duct must be taken into consideration when calculating the distance between the machine and a wall or other appliances or furniture on either side.
–A special conversion kit* is re- quired.
The machine lid is replaced by a coverplate which must be fitted by suitably qualified person to ensure electrical safety. This kit is supplied with installation instructions.
–When installing under a 900/910 mm high worktop a spacer kit* is re- quired.
–Flat type ducting* is required if there is not enough space for a vent duct.
–The electric socket must be located in an accessible position near the machine.
When built under running times may be longer.
NOTE:
If you wish to push your machine under a worktop and there is space to do this without removing the lid, the coversion kit is not necessary. Otherwise the con- version kit is essential.
When building under allow for 625 mm to include hoses, lid, facia and door.
When building the machine in behind cabinet doors, ensure that doors are open during operation for adequate ventilation.
Replacing the lid
If the lid has been removed in order to fit a cover plate, ensure that, if the lid is replaced, it fits securely into the rear holders. Otherwise, it is not properly se- cure for transport.
Washer-dryer stack
The tumble dryer can also be com- bined with a Miele washing machine in a
A washer and dryer should never be stacked without using the proper stack- ing kit. Doing so is extremely danger- ous, as the dryer may vibrate off of the washing machine during use.
All parts marked * are available from the Miele Spare Parts or Sales Departement, and must be fitted by a suitably competent person according to the instructions supplied with the kit.
26