Miele T 220 At the end of a programme, Selecting a different programme, Interrupting a programme

Page 16

How to dry correctly

Selecting a different programme

As long as the cooling down phase or the anti-crease phase has not been reached, it is possible to change a programme after it has started by turn- ing the programme selector to a differ- ent programme position.

Interrupting a programme

^Switch the machine off with the I-On /0-Offbutton.

To continue drying:

^Switch the machine on with the I-On /0-Offbutton.

With COTTONS and MINIMUM IRON programmes the programme will con- tinue unless the cooling down or anti-crease phase has been reached.

With other programmes:

^Press the START button.

Adding or removing items

^Open the door. Take out or add items as required.

^To continue drying close the door and press START.

To cancel a programme

^Turn the programme selector to Fin- ish or open the door .

The programme has been successfully cancelled when only the Anti-crease/Finishindicator lamp is on.

At the end of a programme

At the end of a programme the Anti-crease/Finishlamp will come on in the sequence display and the buzzer will sound.

The drum will continue to rotate at inter- vals to prevent laundry creasing, if you do not wish to remove it immediately (anti-crease). The anti-crease phase lasts for a maximum of 60 minutes, ex- cept with Woollens hand care programme.

^Press the Door button and open the drum door.

^Remove the laundry.

Make sure that the drum is empty. If items are left in the dryer, they could be damaged by overdrying when the dryer is next used.

^Clean the filter.

^Close the door.

^Switch the dryer off by pressing the l-On/0-Offbutton.

16

Image 16
Contents Operating instructions for vented tumble dryer T Contents Consumption data Technical data Technical safety Correct useOperation Page Using accessories Caring for the environment Disposal of the packing materialDisposal of your old appliance Energy saving tipsControl panel Programme selectorProgramme sequence and check lamps Start button Door buttonTips on drying Wash care labelsLow temperature Programmes Fabric type Special notesNormal+ NormalProgramme chart Minimum IronHand care SmoothingWarm air Cool airLoad the drum Switch on the dryer How to dry correctlyPrepare the laundry Select a programme Start the programmeTo cancel a programme At the end of a programmeSelecting a different programme Interrupting a programmeCleaning the fluff filter Cleaning and careTumble dryer Problem solving guide Problem Possible cause Remedy There is a build up FluffLaundry is not suffi Ciently dryEven switches off Problem Possible cause Remedy Drying processGoes on too long or Tons or Minimum Iron programme. If the drum is Programme againTo change the interior drum lamp PC indicator lamp Interface for service technicians After sales serviceRepairs Installation Front viewTransporting the machine to its installation site InstallationAligning the machine Replacing the lid Installation siteWasher-dryer stack Electrical connection Installation venting ProcedureGeneral AvoidTo calculate the effective duct length Calculating the effective duct lengthInternal duct diameter At the rear Calculation exampleLeft or right side of the machine Venting systems overview Venting system with Flexible ducting hoseInstallation examples venting sys- tem with flexible hose Venting system with plastic piping ExampleConnecting directly to a wall vent Main venting duct Washer dryer stack Height of venting outlet for washer dryer stackConsumption data CottonsTechnical data Programmable functions for changing standard settings Is switched on Programmable functionsIncreased drying level in the Cottons programmes To checkIncreased drying level in the Minimum Iron programmes Buzzer