Control panel message

Description

Recommended action

 

 

 

INCOMPATIBLE SUPPLIES

At least two supplies are installed that are not

1. Press to access the SUPPLIES

alternates with

intended for use in this device.

STATUS menu.

 

 

For status press

The supplies gauge will display the consumption levels of print cartridges.

2.Press and to highlight the specific supply that has a problem.

3.Press to view help for the supply.

4.Press and to step through the instructions.

Incorrect PIN

The wrong PIN was entered. After three

Re-enter PIN correctly.

 

incorrect PIN entries, the printer will return

 

 

 

 

 

to Ready.

 

 

 

 

 

 

 

 

Initializing

Displayed when the printer is turned on to

No action necessary.

 

permanent storage

show that permanent storage is being

 

 

 

 

initialized.

 

 

 

 

 

 

 

 

Initializing...

This message is displayed when the printer

No action necessary.

 

 

is turned on, as soon as the individual tasks

 

 

 

 

 

begin initialization.

 

 

 

 

 

 

 

INSERT OR CLOSE

Tray XX must be inserted or closed before the

Close the tray indicated.

TRAY X

current job can be printed.

 

 

 

 

 

 

 

 

 

For help press

 

 

 

 

 

 

 

 

INSTALL FUSER

The fuser is not installed or is not installed

Confirm that the fuser is installed in the printer

 

correctly.

and is fully seated.

 

 

 

Press to see step by step information.

 

 

 

 

 

INSTALL SUPPLIES

At least one supply item is missing or is not

1.

Press

to access the SUPPLIES

For status press

correctly seated in the printer and another

 

STATUS menu.

 

supply item is missing, incorrectly placed,

2.

Press

and

to highlight the specific

The supplies gauge will display the

out, or low. Insert the supply item or make

sure the installed supply item is fully seated.

 

supply that has a problem.

consumption levels of print cartridges.

 

3.

 

 

 

 

 

Press

to view help for the supply.

 

 

4.

Press

and

to step through the

 

 

 

instructions.

 

 

 

 

 

 

INSTALL TRANSFER UNIT

The transfer unit is not installed or is not

1.

Press

to access the SUPPLIES

 

installed correctly.

 

STATUS menu.

 

 

 

2.

Press

to highlight the transfer unit.

 

 

3.

Press

to view help.

 

 

4.

Press

and

to step through the

 

 

 

instructions.

 

 

 

 

 

INSUFFICIENT MEMORY

The device does not have enough memory to

1.

To use the device without the data,

TO LOAD FONTS/DATA

load the data, such as fonts or macros from

 

press .

 

 

the location specified. Device can be one of

2.

To solve the problem, add more

 

the following:

For help press

 

 

memory to the device. DDR SDRAM

alternates with

INTERNAL = ROM directly on the formatter

 

Memory: 128MB, (Q2630A) or 256MB

board

 

(Q2631A).

 

Device

CARD SLOT X = font card in slot X

 

 

 

 

 

 

 

 

 

 

170 Chapter 8 Problem solving

ENWW