8.Press or to select the appropriate setting.

9.Press to set the selection.

10.Press Menu.

Auto continue

You can determine printer behavior when the system generates an Auto Continuable error. ON is the default setting.

ON displays an error message for ten seconds before automatically continuing to print.

OFF pauses printing any time the printer displays an error message and until you press .

Setting auto continue

1.Press Menu to enter the MENUS.

2.Press to highlight CONFIGURE DEVICE.

3.Press to select CONFIGURE DEVICE.

4.Press to highlight SYSTEM SETUP.

5.Press to select SYSTEM SETUP.

6.Press to highlight AUTO CONTINUE.

7.Press to select AUTO CONTINUE.

8.Press or to select the appropriate setting.

9.Press to set the selection.

10.Press Menu.

Replace supplies

The printer allows three options for handling the printer when a color cartridge is low and should be replaced. STOP AT LOW is the default value.

STOP AT OUT pauses printing until the color supply is replaced. The control panel displays a warning that the supply is low and should be replaced.

STOP AT LOW allows the printer to continue printing until the color supply is exhausted. The control panel displays a warning that the supply is out and should be replaced.

OVERRIDE AT OUT allows printing to continue when a color supply is out, but displays a warning that override is in use and that the supply must be replaced.

NOTE Using the Override mode may result in unsatisfactory print quality. HP recommends replacing the supply when the REPLACE SUPPLIES Override in use message is displayed. HP Supplies Premium Protection Warranty coverage ends when a supply is used in Override mode.

62 Chapter 2 Control panel

ENWW

Page 78
Image 78
HP CP4005 manual Auto continue, Replace supplies, Setting auto continue