HP CP4005 manual To Stop AT OUT, Request accepted, Resend, Restoring

Control panel message	Description	Recommended action
<Current status message>
REPLACE TRANSFER KIT	The transfer unit is at end of life. Printing can	1. Open the top and front cover.
For help press	continue but print quality might be reduced.	2. Lower the transfer unit by pulling the
			green handle at the top of the unit
			downward.
		3.	Depress the small blue latches located
			on either side of the bottom of the
			transfer unit and lift the unit out of the
			printer.
		4.	Install the new transfer unit.
		5.	Close the front and top covers.
		6.	Supplies ordering information is also
			available from the embedded Web
			server. See Using the embedded Web
			server for more information.
REPLACE TRANSFER KIT	The transfer unit is nearing the end of its	1. Order the transfer kit.
	useful life and the REPLACE SUPPLIES	2.	To continue printing, press .
For help press	setting in the SYSTEM SETUP menu is set
alternates with	to STOP AT OUT.	3. To replace the transfer kit, perform the
REPLACE TRANSFER KIT			following steps:
			● Open the top and front cover.
			● Lower the transfer unit by pulling
			the green handle at the top of the
			unit downward.
			● Depress the small blue latches
			located on either side of the bottom
			of the transfer unit and lift the unit
			out of the printer.
			● Install the new transfer unit.
			● Close the front and top covers.
			● Supplies ordering information is
			also available from the embedded
			Web server. See Using the
			embedded Web server for more
			information.
Request accepted	The printer has accepted a request to print an	No action necessary.
please wait	internal page, but the current job must finish
	printing before the internal page will print.
Resend	The firmware upgrade was not completed	Attempt upgrade again.
upgrade	successfully.
Restoring...	The printer is restoring external accessory	No action necessary.
[accessory #]	settings in response to a user request.
Restoring...	The printer is restoring settings. This	No action necessary.
	message is displayed during the execution of

ENWW Control panel messages 179