HP CP4005 manual Intermittent Mode, RAM Disk Device, RAM Disk File, RAM Disk is, Reinsert Duplexer

Control panel message	Description	Recommended action
Processing...	The printer is currently processing or printing	No action necessary.
copy <X> of <Y>	collated copies. The message indicates that
	copy X of Y total copies is currently being
	processed.
Processing...	This message might be displayed during	Press		to see step by step information.
INTERMITTENT MODE	periods of heavy usage if the printer becomes
	overheated. If this occurs, the printer enters
For help press	a mode in which it prints for one minute and
	pauses for one minute. This cycle continues
	until the operating temperature stabilizes.
RAM DISK DEVICE	A device failure has occurred on the specified	1.	To clear the message, press the		key.
FAILURE	drive.	2. If the message persists, turn the printer
To clear press			off then on.
		3.	If the message persists, contact
alternates with
			HP Support at http://www.hp.com/
Ready			support/ljcp4005.
RAM DISK FILE	The printer received a PJL file system	1.	To clear the message, press the		key.
OPERATION FAILED	command that attempted to perform an	2. If the message persists, turn the printer
	illogical operation (for example, to download
To clear press	a file to a non-existent directory).		off then on.
		3. If the message reappears, there may be
alternates with	Printing may continue.
			a problem with the software application.
Ready
RAM DISK IS	The file system device is protected and no	1. To enable writing to the RAM disk, turn
WRITE PROTECTED	new files can be written to it.		off write protection, using HP Web
			Jetadmin software.
To clear press		2.	To clear the message, press the		key.
alternates with		3. If the message persists, turn the printer
Ready			off then on.
Ready	The printer is online and ready for data. No	No action necessary.
The supplies gauge will display the	status or device attendance messages are
	pending at the display.
consumption levels of print cartridges.
Ready	The printer is in a special diagnostics mode.	Press the Stop key to exit the special
Diagnostics mode		diagnostics mode.
		OR
To exit press. Stop
		No action is necessary.
Ready	The printer is online and ready.	No action necessary.
IP Address:
Receiving	A firmware upgrade is in progress.	Do not turn the printer off until the printer
upgrade		returns to Ready.
REINSERT DUPLEXER	The duplexer has been removed.	Press		to see step by step information.
REMOVE ALL	The printer is executing a component test and	Remove all print cartridges.
	the component selected is Belt Only.

176 Chapter 8 Problem solving ENWW