Setting the default gateway

1.Press Menu to enter the MENUS.

2.Press to highlight CONFIGURE DEVICE.

3.Press to select CONFIGURE DEVICE.

4.Press to highlight I/O.

5.Press to select I/O.

6.Press to highlight EMBEDDED JETDIRECT MENU.

7.Press to select EMBEDDED JETDIRECT MENU.

8.Press to highlight TCP/IP.

9.Press to select TCP/IP.

10.Press to highlight MANUAL SETTINGS.

11.Press to select MANUAL SETTINGS.

12.Press to highlight DEFAULT GATEWAY.

13.Press to select DEFAULT GATEWAY.

NOTE The first set of the three sets of numbers shows the default settings. If there is not a number highlighted, a highlighted empty underscore appears.

14.Press or to increase or decrease the number for configuring DEFAULT GATEWAY.

15.Press to move to the next set of numbers.

16.Repeat steps 15 and 16 until the correct subnet mask is entered.

17.Press the Menu button to return to the Ready state.

72 Chapter 3 I/O configuration

ENWW

Page 88
Image 88
HP CP4005 manual Setting the default gateway