Hitachi BW-80S Installation, How to install and remove the water supply hose, 供水管的安裝方法和拆卸方法

Page 11

Installation

安裝

Attention 註意

Please turn on the water tap to check to connecting condition of the water supply hose before washing.

開始洗衣前,請先打開水龍頭,檢查供水管的連接狀況。

To prevent damages caused by water leakage due to loose screw.

如果螺釘鬆脫,會因漏水而招致不必要的損失。

How to install and remove the water supply hose

供水管的安裝方法和拆卸方法

Water tap

水龍頭

Do not allow water tap, one touch joint and rubber ring to touch the washing machine when installing them. 安裝水龍頭、便捷連接器以及滑環時,註意別讓它們碰 到洗衣機機體。

Main unit

機體

Turn the union nut in the direction as shown by the arrow and firmly connect it to the water inlet.

沿箭頭方向旋轉連接螺母,使其與供水口緊

Installing

安裝方法

1Push down the rubber ring and insert the tap into the

one touch joint.

將滑環下壓,然後插入便捷連 接器內。

2Release the rubber ring and push up the water supply

hose until it clicks.

放開滑環,向上推壓供水管, 直至發出的鎖緊聲為 止。

One touch joint

Latch

Rubber ring

Water supply hose

Turn off

Latch

緊相連。

Attention註意

Firmly tighten the union nut when connecting the water supply hose to the water inlet.

請務必旋緊供水管與供水口的連接螺母。

Failure to do so may result in water leakage.

螺母鬆脫的話,可能會漏水。

Union nut

• Pull the water supply hose to

Rubber ring

confi rm that it does not come

 

off easily.

拉一拉供水管,確認供水管 不會脫落。

Removing

拆卸方法

1Turn off the water tap.

關閉水龍頭。

2Press the start button and let the machine run for about ten seconds.

按下啟動按鈕,運轉10秒鐘。

This is to prevent water splashing when removing the tap.

為了防止拆卸時水花四濺。

3Remove the latch and the water supply hose while pushing down the rubber ring.

鬆開搭扣,拉下滑環,同時將供水管拔下。

Loosely tightened union nut will cause water

leakage.

連接螺母如不擰緊,可能產生漏水現象。

When removing the hose, unscrew the union

nut fi rst.

拆卸時,擰下連接螺母,即可拆除。

Please use the water supply hose and one

touch joint supplied in the package.

請使用隨機配套的供水管和便捷連接器。

The appliance is to be connected to the water mains using new hose set and that old hose-

set should not be reused.

應使用附帶的新的連接水管進行連接,舊的連接 水管不得再次使用。

11

CSH13H0048_BW-80S.indb 11

2013/10/15 15:11:50

Image 11
Contents Model BW-80S Contents Circular Motion Penetration 迴旋滲透 Key FeaturesWater-saving circulating water flow 節水型循環水流 Nano Titanium filter自動筒清洗 About Auto Self CleanAuto Self Clean 關於自動筒清洗安全方面的註意事項 Safety Precautions安全方面的註意事項(續) Keep hands and feet away from When installing the washing machinePlease turn off the water tap when not Using the unit Proof fabric or cloth安裝指南 Installation GuideInstallation of Washing Machine 洗衣機的安裝 Installation of the bottom plate 底板的安裝Water Drainage Hose Related Parts 排水管的相關部件 How to Install the Water Drainage Hose 排水管的安裝供水管的安裝 How to Install the Water Supply HoseHow to Install the One Touch Joint 安裝指南(續)供水管的安裝方法和拆卸方法 InstallationHow to install and remove the water supply hose 在一般家庭以外使用時 Safety CheckWashing Machine Repair 如出現下列情況或其它異常現象,請立即拔下電源插頭,務必向有關的經銷商委託檢查、修理。(可能根據 實際情況收取費用)後面的數字表示詳細說明的頁數。 Technical Description各部件名稱 Inhaling window控制面板 Control PanelRemaining time will indicate at the end of operation Cancellation for loosening & spinning關於機蓋緊鎖裝置 About the Lid Lock HoldPreparation for laundry Before Using Your Machine開始洗衣前 Preparation for washing machine檢測洗衣量和水位顯示 How to put laundry開始洗衣前(續) Checking Amount of Laundry and Displaying Water Level將洗衣劑放入洗衣劑 漂白劑投入盒內。 How to Use Liquid Detergent, Bleach and Fabric Softener洗衣劑、漂白劑、柔軟劑的使用方法 Put the detergent in the detergent bleach feeding caseLiquid bleach 液體漂白劑 洗衣劑、漂白劑、柔軟劑的使用方法(續)Approximate amount of fabric softener 柔軟劑的大致用量 20L 25L 30L 35L 40L 45L 55L 60LAmount Amount of Laundry and Detergent洗衣量和洗衣劑量 Synthetic detergent 合成洗衣劑Liquid detergent Power synthetic DetergentSelection of Laundry Program 洗衣程序的選擇方法Washing This part describes the process of each program Content of Laundry Program~6min ~1min 60minChange of the options in the processes Switch of processesTime required for washing Use Guidelines 使用中的註意事項 開始洗衣前 Before using your machineProgram Description Method to take out How to put in comforter and blanket 被子和被毯的放入方法After the end of washing 洗衣結束後洗衣蓋的安裝方法 Using the Washing CapInstallation of the washing cap 使用洗衣蓋Taking out the washing cap Adjustment of the position and height of the washing cap使用洗衣蓋(續) 調整洗衣蓋的位置高度毛絨程序 Washing laundry with Dry clean labelBefore using your machine Wool ProgramVerify if the laundry will decolor 毛絨程序(續)Preparation for washing Preparation for the laundryUse of detergent Use of detergentDrying methods Treatment recovery of the shrinkage and deformationAfter washing 預校時間洗衣 Using the Timer for WashingPut the laundry in and press the Power ON/OFF button Press the Preset button , set the preset time預校時間洗衣(續) How to use the Preset button Switched optionsFix the preset duration press the Preset button 開始風乾前 AIR-JET Program風乾程序 Preparing for AIR-JET按下「啟動/暫停」按鈕 。 風乾程序(續)Air-jet Program 風乾方法縮短晾曬時間 Proposed Operation Time建議使用時間表 Shorten Laundry Airing Duration按照您喜歡的方式進行洗衣 Washing in Your Favorite WayUse the detergent again Using the Detergent Again按照您喜歡的方式進行洗衣(續) 再次使用洗衣劑筒清洗程序 TUB Clean ProgramRegular maintenance Maintenance先打開吸氣窗,再按下電源按鈕 ,接通電源。 Open inhaling windows and press the Power Switch buttonTUB DRY Program 筒風乾程序Pay attention to the rust on the washing basket Maintenance and Repair維護保養方法 納米鈦空氣過濾網的維護 Maintenance of nano titanium filterHow to maintain the water feed port Please pay attention to such cases during operation Maintenance of water supply boxRemove the internal lid and clean it 維護保養方法(續)供水口的保養 How to maintain the water inletMaintenance to the main unit Please use the soft cloth to wipe and clean the dirt onWhen icing is possibly underway 關於異常警報 When Failure HappensAbout the abnormality alarm 有故障發生時Please recheck the following items 有故障發生時(續)No buzz at the end of washing It does not work after setting of air-jet dryUnable to air-jet dry Abnormal sound occursFollowing cases are not failures 以下現象並非故障 Level Case 現 象Spinning About WaterDuration PowerSwitch Washing备備忘錄 Extended water drainage hose about 80 cm Optional PartsProduct Specifications Extended water supply hose Washing cap Lint filter