
Control Panel
控制面板
Washing indicator
The indicators of washing, rinsing and spinning display the ongoing process and its duration.
•During the washing machine operation, the display (lighting, flashing, darkening) of indicator of each process describes the operation status and the working process to the user.
Air Jet indicator
Please select the proper
Lid Lock indicator
Lid Lock indicator will light when the lid is in locked status.
Before spinning, the lid will automatically lock.
After power on, press this button for 3 seconds to change setting. 3
Change buzzer sound. | 16 |
Press and hold for 3 seconds in "NORMAL" process, the lid will be automatically locked after water supply of WASH process. (safe mode)
3
( )16
Finish beep can be cancelled
16
"Loosening process" for rearrangement can be cancelled.
15
WASH RINSE SPIN button
Used to set WASH, RINSE, SPIN process or change setting.
After the washing machine starting, please press "PAUSE" button temporarily.The setting could not be changed after washing completes.
(Some processes cannot be changed. )
()
■Automatic power OFF
電源自動關閉功能
■The power will be cut automatically at the end of operation.
運轉結束後,電源開關將自動切斷。
■The power will be automatically cut if the wash- ing machine keeps one of the following status for above 1 hour.
在下列情況中,若將洗衣機放置1小時以上,則電源開 關將自動切斷。
1)Pause
暫停狀態
2)Lid open
機蓋開啟的狀態
3)Abnormality alarm describer in page 49
如同49頁的異常警報狀態
■With no pressing on "START/PAUSE" button in 5 minutes after the power on, the power will be cut off automatically.
接通電源後,若不按下啟動按鈕,則5分鐘之後電源開 關將自動切斷。
14
AIR JET button |
| PRESET button | START/PAUSE button | |
|
|
|
| 啟 / |
|
|
|
|
|
Used to set |
| Used for operation with | Used for start or pause | |
|
| PRESET time. 35 | operation. | |
|
|
|
| 啟 |
| 35 |
|
|
The washing machine sound "Hoola, hoola" after the power supply is switched on. About 1 second later, the indicator lights.
1
Two sounds will be heard when selecting options like "60L" in WATER
LEVEL, "15 MIN" in WASH, "WATER STORAGE TWICE" in RINSE, |
| ||
"6 MIN" in SPIN, "3 HR LATER " in PRESET, "30 MIN" in AIRJET, |
| ||
"NORMAL" in WASH process etc. to inform you standard point. |
| ||
60L | 15 | 2 | 6 |
3 |
| 30 |
|
Never press 2 or more buttons at the same timer to prevent misoperation. 2
notes
After the power supply is cut off, the power switch doesn't work within 5 seconds (until the indicator for processes turns off). If the power is to be switched on again, please press the switch after the indicator turning off.
5
2013/10/15 15:11:51