Hitachi BW-80S user manual 有故障發生時（續）, Please recheck the following items

Page 50

When Failure Happens (continued)

有故障發生時（續）

DISPLAY

Alarm content

警報內容

The lid is not locked

completely

(The lid is not completely closed)

機蓋沒有完全鎖緊

（機蓋沒有完全關閉時）

Washing basket can

not rotate

(washing, rinsing, spinning)

洗衣槽無法旋轉

（洗衣、沖洗、脫水）

Part to check

檢查部位

•Is there foreign substance under

the lid?

機蓋下有異物？

•Are the washings oblique?

衣物有無偏斜？

•Or is the washing machine placed

straight? See page 8

洗衣機是否水平放置？ 8

Solution

處理方法

Troubleshooting

排除異常

Restart operation

再次啟動運轉

Please press the "START/PAUSE" button to pause the operation, rearrange the laundry evenly, and restart with

the lid closed. 請按下暫停按鈕暫 停運轉，調整衣物 平衡後，關閉機蓋 重新啟動。

Lock of lid can not be

unlocked

機蓋緊鎖無法解除

•Press "PAUSE" button, and then

restart it.

按下暫停按鈕，然後重新開機。

If there is still trouble, stop using the unit and contact autho-

rized service centre. 若仍出錯，請停止 使用並聯絡日立維 修服務中心。

The rearranging of laundry is abnormal

衣物抖開異常

(Laundries mixed together cannot separate)

（衣物攪在一起抖不開）

•Is there oblique laundry or mixing-

together during air jet or spinning?

風乾中或脫水中衣物有沒有偏置或攪 在一起？

Press PAUSE button and adjust oblique position, and

then restart.

按暫停按鈕，修整 偏置後關閉機蓋， 重新啟動。

•If the above abnormal alarms occur, they may be caused by outside interference.

若出現上述之外的異常警報，有可能是由外來干擾導致。

•At that time, please press the PAUSE button to suspend the washing machine, then restart it. If the same alarms occur, please stop the use and contact authorized service centre.

此時請按下暫停按鈕暫停運轉，然後重新開機，若仍出現相同的異常警報，請停止使用並聯絡日立維修服務中心。

Before the repair request

要求修理前

Case 現 象

Fail to running

不運轉

Please recheck the following items

請再次檢查以下項目

Cause 原 因

•Is power failure?

是否停電?

•Does fuse or breaker blow?

保險絲或熔斷器是否燒斷？

•Can the power plug enter the socket properly?

電源插頭是否可靠地插入電源插座？

•Is the power switched on?

電源開關是否打開？

•Is the tap turned on?

水龍頭是否打開？

•Is the "Timer washing process" set? 35

是否設定了預校洗衣程序？ 35

•Is the "START" button pressed or not?

有無按下啟動按鈕？

50

CSH13H0048_BW-80S.indb 50

2013/10/15 15:12:35

Page 49 Page 51
Image 50
Page 49 Page 51
Contents Model BW-80S Contents Nano Titanium filter Key FeaturesWater-saving circulating water flow 節水型循環水流 Circular Motion Penetration 迴旋滲透關於自動筒清洗 About Auto Self CleanAuto Self Clean 自動筒清洗Safety Precautions 安全方面的註意事項安全方面的註意事項（續） Using the unit Proof fabric or cloth When installing the washing machinePlease turn off the water tap when not Keep hands and feet away fromInstallation of the bottom plate 底板的安裝 Installation GuideInstallation of Washing Machine 洗衣機的安裝 安裝指南How to Install the Water Drainage Hose 排水管的安裝 Water Drainage Hose Related Parts 排水管的相關部件安裝指南（續） How to Install the Water Supply HoseHow to Install the One Touch Joint 供水管的安裝供水管的安裝方法和拆卸方法 InstallationHow to install and remove the water supply hose 如出現下列情況或其它異常現象，請立即拔下電源插頭，務必向有關的經銷商委託檢查、修理。（可能根據 實際情況收取費用） Safety CheckWashing Machine Repair 在一般家庭以外使用時Inhaling window Technical Description各部件名稱 後面的數字表示詳細說明的頁數。Control Panel 控制面板Cancellation for loosening & spinning Remaining time will indicate at the end of operationAbout the Lid Lock Hold 關於機蓋緊鎖裝置Preparation for washing machine Before Using Your Machine開始洗衣前 Preparation for laundryChecking Amount of Laundry and Displaying Water Level How to put laundry開始洗衣前（續） 檢測洗衣量和水位顯示Put the detergent in the detergent bleach feeding case How to Use Liquid Detergent, Bleach and Fabric Softener洗衣劑、漂白劑、柔軟劑的使用方法 將洗衣劑放入洗衣劑 漂白劑投入盒內。20L 25L 30L 35L 40L 45L 55L 60L 洗衣劑、漂白劑、柔軟劑的使用方法（續）Approximate amount of fabric softener 柔軟劑的大致用量 Liquid bleach 液體漂白劑Synthetic detergent 合成洗衣劑 Amount of Laundry and Detergent洗衣量和洗衣劑量 Amount洗衣程序的選擇方法 Power synthetic DetergentSelection of Laundry Program Liquid detergentWashing 60min Content of Laundry Program~6min ~1min This part describes the process of each programChange of the options in the processes Switch of processesTime required for washing Use Guidelines 使用中的註意事項 開始洗衣前 Before using your machineProgram Description 洗衣結束後 How to put in comforter and blanket 被子和被毯的放入方法After the end of washing Method to take out使用洗衣蓋 Using the Washing CapInstallation of the washing cap 洗衣蓋的安裝方法調整洗衣蓋的位置高度 Adjustment of the position and height of the washing cap使用洗衣蓋（續） Taking out the washing capWool Program Washing laundry with Dry clean labelBefore using your machine 毛絨程序Preparation for the laundry 毛絨程序（續）Preparation for washing Verify if the laundry will decolorUse of detergent Use of detergentDrying methods Treatment recovery of the shrinkage and deformationAfter washing Press the Preset button , set the preset time Using the Timer for WashingPut the laundry in and press the Power ON/OFF button 預校時間洗衣預校時間洗衣（續） How to use the Preset button Switched optionsFix the preset duration press the Preset button Preparing for AIR-JET AIR-JET Program風乾程序 開始風乾前風乾方法 風乾程序（續）Air-jet Program 按下「啟動/暫停」按鈕 。Shorten Laundry Airing Duration Proposed Operation Time建議使用時間表 縮短晾曬時間Washing in Your Favorite Way 按照您喜歡的方式進行洗衣再次使用洗衣劑 Using the Detergent Again按照您喜歡的方式進行洗衣（續） Use the detergent againMaintenance TUB Clean ProgramRegular maintenance 筒清洗程序筒風乾程序 Open inhaling windows and press the Power Switch buttonTUB DRY Program 先打開吸氣窗，再按下電源按鈕 ，接通電源。Pay attention to the rust on the washing basket Maintenance and Repair維護保養方法 納米鈦空氣過濾網的維護 Maintenance of nano titanium filterHow to maintain the water feed port 維護保養方法（續） Maintenance of water supply boxRemove the internal lid and clean it Please pay attention to such cases during operationPlease use the soft cloth to wipe and clean the dirt on How to maintain the water inletMaintenance to the main unit 供水口的保養When icing is possibly underway 有故障發生時 When Failure HappensAbout the abnormality alarm 關於異常警報有故障發生時（續） Please recheck the following itemsAbnormal sound occurs It does not work after setting of air-jet dryUnable to air-jet dry No buzz at the end of washingFollowing cases are not failures 以下現象並非故障 About Water Case 現 象Spinning LevelWashing PowerSwitch Duration备備忘錄 Extended water supply hose Washing cap Lint filter Optional PartsProduct Specifications Extended water drainage hose about 80 cm
Top Page Image Contents