KitchenAid YKEHS01P manual Complete Installation, Reinstalling the door

Page 17

3.Remove the 2 screws that hold the handle bracket to the door.

4.Move hinge to the other side and reattach with the 4 screws removed in Step 2.

5.Move handle bracket to the other side and reattach with the 2 screws removed in Step 3.

6.Set the inner door assembly aside.

Reinstalling the door

1.Check for fingerprints on the glass. Clean if necessary.

2.Place the inner door assembly into the outer door assembly. Align the hinge in the opening on the side. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge.

3.Reassemble the inner and outer door assemblies with the 6 screws.

4.Replace the 2 handle screws for the door handle of the door assembly.

5.Use a small flat-blade screwdriver to remove hole plugs in the door opening. Slide the head of the screwdriver under the cap of each hole plug, being careful not to scratch the dryer surface. Lift up. Remove the hole plugs in the door opening and insert in the opposite side.

6.Insert a screw in the second opening from the top of the hinge opening and partially tighten. Hang the door by placing the top hinge keyhole over the second screw head and tighten the screw. By putting this screw in first, the door will hang in place while you insert and tighten the remaining 4 screws.

A B

C

A. Dryer door

B.Dryer

C.Insert this screw first

7.Close the door and check that it latches securely.

Complete Installation

1.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

2.Check to be sure you have all of your tools.

3.Dispose of/recycle all packaging materials.

4.Check the dryer’s final location. Be sure the vent is not crushed or kinked.

5.Check to be sure the dryer is level. See “Level Dryer.”

6.Plug into a grounded outlet. Turn power on.

7.Remove the blue protective film on the console and any tape remaining on the dryer.

8.Read “Dryer Use.”

9.Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust.

10.Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

■Controls are set in a running or “On” position.

■Start button has been pushed firmly.

■Dryer is plugged into a grounded outlet.

■Electrical supply is connected.

■House fuse is intact and tight, or circuit breaker has not tripped.

■Dryer door is closed.

11.When the dryer has been running for 5 minutes, open the dryer door and feel for heat.

If you do not feel heat, turn the dryer off and check the following:

■There may be 2 fuses or circuit breakers for the dryer. Check to make sure both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents FRONT-LOADING Electric Dryer Índice Table of ContentsTable DES Matières Sécurité DE LA Sécheuse Instructions DinstallationYour safety and the safety of others are very important Dryer SafetyToolsand Parts Installation InstructionsOptions Location RequirementsDryer Dimensions Installation clearancesCustom undercounter installation Dryer only Closet installation Dryer onlyElectricalRequirements- U.S.A. Only Electrical Requirements -Canada Only If connecting by direct wireElectrical Connection -U.S.A. Only Power Supply CordDirect Wire DEG Wire connection Power supply cordWire connection Direct wire BDE CG F VentingRequirements Optional 3-wire connectionPlan Vent System Angled hood style shown following is acceptable InstallVent SystemInstallLeveling Legs Connect Vent Level DryerReverse Door Swing Remove the doorReinstalling the door Complete InstallationClose the door and check that it latches securely If the dryer will not start, check the followingTo use an Automatic Cycle Dryer USEStartingYour Dryer Stopping Your Dryer Pausingor RestartingControlLocked LoadingCycles StatusLightsAdditional Features DryingRack Cycle End SignalDryer Care Changing the Drum Light TroubleshootingCanada Assistance or ServiceU.S.A KitchenAid will not pay for Kitchenaid Dryer WarrantySu seguridad y la seguridad de los demás es muy importante Seguridad DE LA SecadoraHerramientas ypiezas Instrucciones DE InstalaciónOpciones Requisitosde ubicaciónInstalación en un clóset Sólo para la secadora Dimensiones de la secadoraEspacios para la instalación Espacio mínimo para la instalación en un armario Requisitoseléctricos- EE. UULas instalaciones en casas rodantes necesitan Usted es responsable deSi hace la conexión con cableado directo Si emplea un cable de suministro eléctricoSi el contacto de pared luce como éste Cableado directo Conexión eléctrica Sólo en EE. UUCable de suministro eléctrico Conectar con Conexión de 4 hilos Cordón de suministro de corrienteSaque el tornillo central del bloque terminal Una caja deConexión de 4 hilos Cable directo Conexión de 3 hilos Cordón de suministro eléctricoConexión opcional de 3 hilos Conexión de 3 hilos Cable directoInstalaciones típicas de escape Requisitosde ventilaciónPlanificación del sistema de ventilación Cálculo de la longitud del ducto de escape Instalaciones opcionales de escapeInstalaciones alternas para espacios limitados Instalación de las patas niveladoras Instalación delsistema de ventilaciónConexión del ducto de escape Nivelación de la secadoraCómo invertir elcierre de la puerta Cómo quitar la puertaCómo volver a instalar la puerta Complete la instalaciónCierre la puerta y fíjese que se cierre con seguridad Lea Uso de la secadoraPuesta en marcha de la secadora USO DE LA SecadoraPara usar un ciclo Automático Dirija el selector hacia un ciclo AutomáticoPausa o reanudación de la marcha Detención de la marcha de la secadoraControlbloqueado CómocargarCiclos Luces de estadoCaracterísticasadicionales Estante de secado Alarma de Fin de Ciclo Cycle End SignalSólo aire Air Only Cuando use Sólo aireLimpieza dellugar donde está la secadora Cuidado DE LA SecadoraLimpieza del filtro de pelusa Limpieza de cada cargaEliminación de pelusa acumulada Limpieza del interior de la secadoraCuidado para las vacaciones y la mudanza Cambiode la luz del tamborLa ropa no se está secando bien Solución DE ProblemasSonidos raros Pelusa en la ropaAyuda O Servicio Técnico KitchenAid no pagará por Garantía DE LA Secadora KitchenaidVotre sécurité et celle des autres est très importante Sécurité DE LA SécheuseOutillage etpiècesnécessaires Instructions DinstallationEmplacement d’installation Installation dans un placard Sécheuse seulement Espacements dinstallationDimensions de la sécheuse Spécifications électriques Canada seulement Linstallation dans une maison mobile exige’est à l’utilisateur qu’incombe la responsabilité de Ne pas utiliser de cordon de rallongeInstructions DE Liaison À LA Terre Exigencesconcernantl’évacuationInstallations d’évacuation facultatives Installations typiques d’évacuationAutres installations où le dégagement est réduit Planification du système dévacuationLe clapet incliné illustré ci-dessous est acceptable Installation du conduit d’évacuationDétermination de la longueur du conduit Mise à niveau de la sécheuse Installation despiedsde nivellementConduitd’évacuation Inversion de louverture de la porteInverser la charnière et son support Réinstallation de la porteSi la sécheuse ne démarre pas, vérifier ce qui suit Achever l’installationFermer la porte et vérifier qu’elle s’enclenche solidement Utilisation dun programme automatique Utilisation DE LA SécheuseMise en marche de la sécheuse Arrêt de la sécheuse Verrouillage descommandesArrêt ou remise en marche ChargementTémoins lumineux Conseilspour le séchage et les programmesProgrammes Caractéristiques supplémentaires Grille de séchage Entretien DE LA Sécheuse Nettoyage de lemplacement de la sécheuseNettoyage du filtre à charpie Nettoyage à chaque chargeChangementde l’ampoule d’éclairage Du tambour Nettoyage de l’intérieur de la sécheuseRetraitde la charpie accumulée Dépannage Assistance OU Service KitchenAid Canada ne paiera pas pour Garantie DE LA Sécheuse KitchenaidAll rights reserved 8557328A

YKEHS01P, KEHS01P specifications

The KitchenAid KEHS01P and YKEHS01P stand mixers are emblematic of KitchenAid's commitment to quality, durability, and innovative design in kitchen appliances. These stand mixers have become essential tools for both amateur home bakers and professional chefs, bringing versatility and performance to every kitchen.

One of the most notable features of the KEHS01P and YKEHS01P is their powerful motor. With a robust engine that delivers reliable torque, these mixers can handle a wide range of tasks, from whipping egg whites to kneading thick bread dough. This level of power ensures that users can mix even the heaviest of ingredients effortlessly.

Both models come equipped with the signature 10-speed slide control, which allows for precise adjustments to suit different mixing techniques and recipes. Whether it’s a slow stir, a moderate mix, or a fast whip, the seamless transition between speeds provides optimal control over the mixing process. This feature is especially beneficial when dealing with delicate ingredients that require a gentle touch.

The tilt-head design of the KEHS01P and YKEHS01P makes it easy to access the mixing bowl and change attachments, allowing for quick ingredient additions and simple cleaning. The mixers are compatible with a wide range of accessories and attachments that expand their functionality, from pasta makers to food grinders, enhancing their versatility in the kitchen.

Another key characteristic of these stand mixers is their sturdy construction. Made with a durable metal housing, the stand mixers provide stability during use and ensure long-lasting performance. Their compact yet powerful design means they can easily fit into any kitchen countertop without sacrificing functionality.

The mixing bowl included with these models is typically a generous 4.5-quart capacity, perfect for preparing large batches of dough or batter. The stainless-steel bowl is not only easy to clean but is also designed to resist rust and wear over time, adding to the longevity of the product.

In addition to functionality, style is not overlooked. KitchenAid offers a variety of colors and finishes, allowing users to find a model that fits their kitchen aesthetic.

Overall, the KitchenAid KEHS01P and YKEHS01P models embody a blend of power, precision, and style. They are designed to inspire culinary creativity while making the baking and cooking experience enjoyable and efficient. With their impressive features and reliable performance, these stand mixers are truly a worthy investment for anyone who loves to cook or bake.
Top Page Image Contents