Fisher & Paykel WL37T26D Out-of-Balance recovery routine, Reset Back to Factory Settings

Changing pre-set options

31

Out-of-Balance recovery routine

When your AquaSmart™ is spinning it can sense if the wash load is out-of-balance and will stop and re-try spinning up to 3 times. If it still senses an unbalanced load there are two options the machine can take.

Automatic Recovery option

Your AquaSmart™ will try to automatically correct the out-of-balance load. It will fill with water and agitate to redistribute the load before trying to spin up again.

Machine Stops option

Your AquaSmart™ will stop, give a short burst of beeps every 5 seconds, and the spin speed lights will flash. You must redistribute the load more evenly yourself. (Use this option if you wish to conserve water).

Your washer arrived with the ‘Machine Stops’ option set.

1Enter Options Adjustment mode (refer to page 28).

2Select SOAK to program your AquaSmart™ to automatically recover.

3Press POWER to save your selection.

Reset Back to Factory Settings

If you would like to reset all settings back to those that were set when your AquaSmart™ left the factory you have the option of selecting RESET DEFAULTS.

1Enter Option Adjust Mode (page 28).

2Press and hold the START /PAUSE button until you hear one quick beep. This indicates that all settings have been returned to the factory default settings.

EN

SOAK

light on = automatic recovery

SOAK

light off =machine stops

Fig.18 Adjusting Out-of-Balance recovery routine

Fig 19. Resetting factory defaults