Fisher & Paykel WL37T26D installation instructions Drain hose, Inlet hoses, To prevent siphoning

Installation instructions

9

Drain hose				EN
1 Carefully pull the drain hose out from the	Pull hose
back of the washer by pulling the exposed	through guide		mm)
part of the hose downwards and outwards.				¾” (20 mm)
2 To guide the drain hose over the set tub/sink			1200
				maximum
or standpipe the hose guide MUST be fitted			–
to the drain hose.			(850
To prevent siphoning:			to 78”
The drain hose should not extend more than
¾” (20 mm) from the end of the guide.			½”
The height of the standpipe or set tub/sink			33
		Flex hose	Standpipe
3 Place the drain hose in the set tub/sink or
should be between 33 ½” to 78” (850 – 1200 mm).		guide apart
The drain hose can be trimmed to length.
standpipe.		Fig.2 Fitting the drain hose guide

Important!

In multi-storey apartments or any upper floor installation, the washer should be installed on a drained floor.

Check that the tub or standpipe is free from lint or other obstructions before operating the washer. In a basement installation do not exceed a standpipe height of 96” (2438 mm).

Inlet hoses

1Install hoses with the straight end (with filters) fitted to the faucets (refer to Fig.3).

2Install elbow ends onto clothes washer (inlet valves are marked on the back of the washer H=hot, C=cold) (refer to Fig.4).

Fig.3 Faucet end of hose Fig.4 Washer end of hose