Before you call for service
35
The COLD water temperature light is flashing | EN |
Check that the cold water supply has been turned on.
Your cold water temperature may exceed the recommended limits (refer to
Installation instructions pages 6 – 11).
Check that the inlet hose filter is not blocked.
Check that the inlet hose filter is not kinked or squashed.
Check that the inlet hoses have been connected to the correct faucets.
The flow rate of the supply water may be too slow.
The WASH cycle light is flashing
Your washer is overloaded and cannot continue the cycle.
Ensure the washer is stationary and remove items until the remaining ones can move freely.
Check that the washer is not siphoning (refer to Installation instructions pages 6 – 11).
The RINSE and SPIN lights are flashing
Your washer has a suds
Ensure that you are using a HE Low Sudsing or Front Loader type detergent.
Wait for suds to dissolve (about 20 minutes).
Rinse clothing using the RINSE and SPIN cycle, or run through another cycle.
For a bulky load, press down as far as possible and press START/PAUSE.
The LID LOCK light is flashing
Check that the lid is closed.
Press START/PAUSE.
If the symptom persists, call your Fisher and Paykel Dealer or Authorized Service Center.
Single beep every second and …
The service light (spanner icon) is flashing
1.Turn your washer off at the wall.
2.Wait 1 minute and turn it back on.
3.Check your washer is level (refer to installation instructions pages 6 – 11).
4.Remove load and retry.
5.Put through a RINSE and SPIN cycle.
6.If the fault
If the washer still will not work, call your Fisher & Paykel Dealer or Authorized Service Agent to arrange service (refer to page 41).